How do axle pins work?
This depresses the two ball-bearings at the far end of the axle. This then allows you to insert the axle through the wheel and into the hub. When correctly in place, you release the button. The ball bearings will then click into place providing a secure attachment.
How do you get Legos out of another Lego?
To use the Lego brick separator start by holding one of the two attached bricks down on a surface. Using the other hand use the brick separator and attach it to the other brick. From there press down on the handle of the Lego brick separator with force and you’ll separate the two pieces.
When did the Lego separator come out?
1990
The original LEGO brick separator was introduced in 1990 and was produced until 2011.
How do you remove a hardened pin?
If the pin is too hard to tap, use a hardened, self-tapping screw. Drive the screw into place with a screwdriver. A slide hammer may have to be used to “knock” the bolt and pin assembly from the precision hole.
How do I remove pin?
This is the person-shaped button in either the bottom-right corner of the screen (iPhone) or the top-right corner of the screen (Android). Tap a board to open it. You can remove pins from within your selected board. Tap and hold a pin.
What’s the best way to remove pin from a wire?
Simply slide the pin removal tool between the actuator and switch body for the actuator to pop right off. The connector line removal tools are important to use when you need to replace a terminal, or when you need to re-splice and crimp a wire or terminal.
Where can I get pin and terminal removal tools?
Pin and terminal removal tools are part of our wide assortment of electrical wiring tools. All of our removal tools can be ordered in small quantities but they also come with bulk discounts. For additional information and products to pair with your terminal removal tools, visit the links below:
When to use a connector line removal tool?
The connector line removal tools are important to use when you need to replace a terminal, or when you need to re-splice and crimp a wire or terminal. Using something other than a specified pin removal tool can damage the wire connector, causing more labor and replacement. 1 – 12 of 12
Why do you need to remove pins from harness connectors?
The reason for this article is to help keep wire cutting/splicing to a minimum, not to mention a cleaner, more professional look. Typical uses for removing pins from connectors includes: clutch cut wire install, and knock light install, MAP sensor, MAFT, 90ECU in 91-94DSMs, among many others.