How do I assign a port to a VLAN in Aruba?

How do I assign a port to a VLAN in Aruba?

Creating and Updating VLANs

1. Navigate to the Configuration > Network > VLANs page.
2. Click Add a VLAN to create a new VLAN.
3. In the VLAN ID field, enter a valid VLAN ID.
4. To add physical ports to the VLAN, select Port.
5. (Optional) Click the Wired AAA Profile drop-down list to assign an AAA profile to a VLAN.

How do you check the VLAN configuration on a Juniper switch?

show interfaces vlan

1. Syntax. content_copy zoom_out_map. show interfaces (vlan | vlan.
2. Description. Display status information about routed VLAN interfaces (RVIs).
3. Options. vlan | vlan. vlan-id.
4. Required Privilege Level. view.

How do I create an interface VLAN in Juniper?

To create inter VLAN routing by using routed VLAN interfaces (RVI), perform the following procedure:

1. Create a layer 2 VLAN: root# set vlans vlan-id (1..4094)>
2. Create a logical layer 3 VLAN interface: root# set interfaces vlan unit family inet address

How do I change the trunk port on my Aruba switch?

Navigate to the Configuration > Network > Ports window. In the Port Selection section, click the port you want to configure. For Port Mode select Trunk. To specify the native VLAN, select a VLAN from the Native VLAN drop-down list and click the <– arrow.

How to connect Aruba controller to Juniper switch?

I have connected the Aruba Controller to port ge-0/0/10 on the Juniper switch and configured that port as a trunk port with the native VLAN being UserLAN and the member VLANs as the rest of the VLANs. Juniper port ge-0/0/0 is also configured as a trunk port on the UserLAN VLAN and connects to my firewall that has an IP of 172.0.0.2/22.

What’s the proper connection and VLAN configuration between Juniper?

Juniper port ge-0/0/0 is also configured as a trunk port on the UserLAN VLAN and connects to my firewall that has an IP of 172.0.0.2/22. I can ping public addresses such as 8.8.8.8 from all devices and I have inter-VLAN communication working but I just wanted to ask if this is the correct way to configure these devices?

How to configure an Aruba ex4300 Ethernet switch?

The general steps to configure the EX4300 switch are: Configure the connection to the Aruba ClearPass Policy Manager. Create the access profile used by the 802.1X protocol. Enable HTTP and HTTPS services. Configure the 802.1X protocol. Configure the VLAN used by the guest endpoints. Configure Ethernet switching on the access port.

How to add juniper network as a device?

Add the EX4300 switch as a network device. Under Configuration > Network > Devices, click Add. On the Device tab, enter the hostname and IP address of the switch and the RADIUS shared secret that you configured on the switch. Set the Vendor Name field to Juniper.