Contents
How do I change dimensions on Eagle?
Adjusting the Dimension Layer Use the DELETE tool — — to erase all four of the dimension lines. Then use the WIRE tool — ( — to draw a new outline. Before you draw anything though, go up to the options bar and set the layer to 20 Dimension.
How do they measure Eagles?
The best way to measure things in EAGLE right now is to use a fine grid and the MARK command to define a relative origin or start point and read off the measurement from the coordinates at the top. The Dimension tool can sometimes do a better job but it is limited in the types of objects and measurements it can make.
What does the dimension layer do in Autodesk Eagle?
Some fab houses like OSH Park will use this Dimension layer to generate a board outline Gerber. This will serve as the exact shape of your PCB when they cut it into a fabrication panel. These two layers contain both the top and bottom silkscreen on your PCB, and also component outlines to show the positioning of parts.
Is there a way to change layers in Eagle?
This is certainly possible in Eagle using commands. When using the route tool, the following command will instruct eagle to change layers: layer . Where is the layer you want to be on. If you are currently in the process of routing a trace, Eagle will switch to the new layer at the last point that you clicked
When to change layer / add via whilst routing in Eagle?
If you are currently in the process of routing a trace, Eagle will switch to the new layer at the last point that you clicked and add a via at that location. If you are using the wire tool, eagle will change layer but it will not add a via when it changes the layer.
How to play Eagle dimension tool on YouTube?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: QKM7VU2I_wr86ViQ)