Contents
How do I change the width of a route in Altium?
To change the track width source while routing, press the 3 key on the keyboard. Press Shift+W to select a different value for the User Width. When you change the track width mode, you move between the values defined in the applicable design rule (min/preferred/max), and User Choice.
How do I change dimension units in Altium?
There are some other ways to change the units of measurement in Altium Designer’s layout tool. You can use the command: “Toggle Units” found in the View pulldown menu as shown below. As with the schematic, you can also use the keystroke shortcut combination of “vu” to change the units.
What is ARC in PCB?
An arc is a primitive design object. It is essentially a circular track segment that can be placed on any layer. Arcs can have a variety of uses in PCB layout. Arcs can be open or closed to create a circle (often referred to as a full circle arc).
How do you make a differential pair in Altium?
To create a differential pair object in the PCB editor, click the Add button in the Differential Pairs region of the PCB panel in Differential Pairs Editor mode. In the resulting Differential Pair dialog, select existing nets for both the positive and negative nets, give the pair a name then click OK.
How do you change from mils to mm in Altium?
To make these and other settings changes while editing a schematic library, Go to Tools ► Document Options which will open the Properties panel where you can change from mils to mm and check the box to Show Comment/Designator.
Can PCBS cause arcing?
Today, however, aside from occasional use for inexpensive and unsophisticated overvoltage protection, arcing is an undesirable and dangerous phenomenon on PCBAs. Boards that typically operate at or process high voltages, such as those used in industrial production environments, are most likely to experience arcing.
How to move an arc in Altium Designer?
Move the cursor to adjust the start point for the arc then click or press Enter to anchor it. Move the cursor to change the position of the arc’s end point then click or press Enter to anchor it and complete placement of the arc. Continue placing further arcs or right-click or press Esc to exit placement mode.
When to use minimum arc ratio in interactive routing?
The Minimum Arc Ratio may be applied during any angle interactive routing and also during interactive sliding with Mixed Hugging style. The ratio is used to determine the minimum radius arc allowed when the arc radius falls below this minimum the arc is replaced by track segments, where Min Arc Radius = Min Arc Ratio x Arc Width.
How is interactive routing defined in Altium Designer 21?
This path is defined by placing PCB design objects, such as tracks, arcs, and vias, on the copper layers to create a continuous connection between the nodes. Rather than placing these objects one by one to build up the connective path, you interactively route the connection. In the PCB editor, interactive routing is an intelligent process.
How to change track width in Altium Designer?
If you forget any of the in-command shortcuts, press Shift+F1 to display a list while running the command. To change the track width source while routing, press the 3 key on the keyboard. Press Shift+W to select a different value for the User Width.