Contents
How do I communicate from one VLAN to another VLAN?
In the same way, a Router is what we will need in order for hosts in different VLANs to communicate with one another. There are three options available in order to enable routing between the VLANs: Router with a Separate Physical Interface in each VLAN. Router with a Sub-Interface in each VLAN.
How do VLANs communicate among each other?
Two separate VLANs must communicate through a layer-3 device, like a router. Devices on a VLAN communicate with each other using layer-2. Layer-3 must be used to communicate between separate layer-2 domains.
How can hosts on two different VLANs communicate?
Two separate VLANs must communicate through a layer-3 device, like a router. Devices on a VLAN communicate with each other using layer-2. Layer-3 must be used to communicate between separate layer-2 domains.
How does a VLAN send packets to another VLAN?
When a host on one VLAN wants to send something to a host on another VLAN, it must use a layer-3 (e.g. IP) address. The host will use layer-2 to send the frames to its defined gateway (router). The router will strip off the layer-2 frame and inspect the layer-3 packet for the destination layer-3 address.
How to communicate between two VLANs with C3550?
Set up VLAN interfaces in the C3550. Be sure to use the actual VLAN numbers: Have the hosts on each VLAN use the C3550’s address on their VLAN as the default gateway, and the C3550 will route between the two VLANs Good Luck. 08-06-2004 01:21 PM 08-06-2004 01:21 PM Vlan1 x 192.168.99.1 255.255.255.0 Vlan2 x 192.168.11.4 255.255.255.192
How to direct traffic between two VLANs without dynamic protocol?
That should direct traffic between the two VLANs without using a dynamic protocol, and without using a default route which can cause routing loops later on if not done properly. Thet are both directly connected, so they should route without the statics if routing is turned on.