How do I configure a static route between three routers?

How do I configure a static route between three routers?

To make PC0 communicate with PC1 we must configure route,because they are in different network and is connected via routers.

1. STEP:1- CONFIGURATION ON ROUTER R1:
2. STEP:2- CONFIGURATION ON ROUTER R2:
3. STEP:3-CONFIGURATION ON ROUTER R3:
4. STEP:4- TEST PC0 and PC1 COMMUNICATION USING PING COMMAND.

How do you configure static routing?

Configure a Static Route

1. Network. Virtual Router. and select the virtual router you are configuring, such as.
2. Select the. Static Routes. tab.
3. IPv4. or. IPv6.
4. Add. a. Name.
5. For. Destination. , enter the route and netmask (for example, 192.168.
6. ( Optional. ) For.
7. For. Next Hop. , select one of the following:
8. Enter an. Admin Distance.

How do I configure a layer 3 switch?

Configuring the Layer 3 Interfaces

1. Navigate to the Distribution Switch’s details page from Monitor > Switches.
2. Click Initialize layer 3 under the Status section.
3. Enter the following settings: Name: Uplink. Subnet: 192.168. 128.0/24. Interface IP: 192.168. 128.1. VLAN: 20. Default Gateway: 192.168. 128.254.
4. Click Save.

Can a layer 2 switch handle intervlan routing?

The only way to provide inter vlan routing on a Layer 2 switch is to have a Layer 3 switch or Router in the network which will receive the packets for each Layer2 VLAN and then route them to the other VLAN accordingly.

Can a layer 3 switch be used as a router?

The above feature means that you can implement Layer 3 functionality in your network without using a regular router. If you don’t have a Layer3 switch available, you can also configure InterVLAN routing using a simple Layer2 switch and a Router (also called Router-on-a-Stick).

What do you need to know about layer 3 routing?

Subnet: The network that this static route is for, in CIDR notation (ex. 10.1.1.0/24). Next hop IP: The IP address of the next layer 3 device along the path to this network. This address must exist in a subnet with a routed interface. Click Save or Save and add another if additional static routes are needed.

How to move a layer 3 interface from one switch to another?

To move a layer 3 interface from one switch to another: Navigate to Switch > Configure > Routing and DHCP. Select the layer 3 interfaces that will be moved. Click Edit > Move… Select destination switch or switch stack, then click Submit.