How do I connect my HP switch to my computer?

How do I connect my HP switch to my computer?

For a direct console connection, connect the PC or terminal to the Console serial port using the console cable shipped with the switch. If your PC or terminal has a 25-pin serial connector, first attach a 9-pin to 25-pin straight-through adapter at one end of the console cable.

How do I access the HP ProCurve switch web interface?

To enable web login, log in to the device via the console port, and perform the following configuration: • Enable HTTP or HTTPS service • Configure the IP address of the VLAN interface • Configure a username and password The device supports the following web login methods: • HTTP login: • HTTPS login: The following …

How do I connect my HP ProCurve switch to putty?

1. Connect the Console and Serial adapter together (Female end to the Serial Male end). Locate the Console port on your HP Procurve Switch and plug the console cable into the port, It’s usually located at the front of the device under the logo.

How do I connect to Aruba switch?

To connect a console to the switch, use the RJ-45 console cable shipped with the switch. Alternatively, user can use a USB cable (Not supplied) for a console connection. (See USB Console Port Notes below.) Connect a PC or VT-100 terminal to either of the Console ports.

How do I save configuration on HP switch?

In this case you will see: HP Switch(config)# vlan 20 HP Switch(config)# menu Do you want to save current configuration [y/n]?…There are three ways to save a new configuration:

1. In the CLI: Use the write memory command.
2. In the menu interface: Use the Save command.
3. In the WebAgent: Click Save.

How do I setup my HP ProCurve Switch?

How to: Configure a HP ProCurve switch

1. Step 1: Connect your serial connection.
2. Step 2: Conenct PuTTY.
3. Step 3: Get the IP address.
4. Step 4: Set time server.
5. Step 5: Set SNMP community info.
6. Step 6: Launch the web GUI.
7. Step 7: Configure basic info.
8. Step 8: Create VLANs.

What is part number of HP ProCurve 2626 switch?

The part number of that cable is 5184-1894. The part number is stamped directly on the connectors. Use a VT100-compliant terminal emulator such as Hyper Terminal or Tera Term Pro to make the serial connection with the switch. Use the following COM port settings to create a terminal session with the Switch 4000m:

How to configure HP ProCurve switch in Spiceworks?

Go to ‘Configuration’m then ‘Device Features.’ Under spanning tree, choose ‘ON’, then click ‘Apply Changes’ Step 12: Set passwords (IMPORTANT!) Enter a username and password for both read and read-write level access, then click ‘Apply Changes.’

How to add VLANs to HP ProCurve switch?

As a rule, I don’t tag VLANs on switches where they are not needed, as there is no need for the additional traffic on those switches. Click on ‘Configuration, then ‘VLAN configuration’. Click on the ‘ADD/REMOVE VLANs’ button Specify a friendly name, and the 802.1Q VLAN ID (e.g: 10), then click add VLAN.

What kind of serial cable do I need for my hp switch?

Connect to the console port of your switch via a serial cable. Older switches such as the 2900-48G’s have a 9 pin serial connector on the back of the switch, newer switches have an RJ-45 connection on the front and use a serial> RJ-45 cable. If your laptop does not have have a serial port, you can use a USB-serial adapter.