Contents
How do I connect to MotionEyeOS?
Connect your Pi camera via the CSI connector or plug in a USB webcam using a Micro USB OTG adapter, then apply power. If your setup is correct, the Pi will boot up into MotionEyeOS, and you can use a network scanner like this one to find its IP address. The device will have a default name, such as MEYE-12345678.
What port does MotionEyeOS use?
port 80
motionEyeOS uses port 80 for its web user interface and this is enough for most users.
Where do I put WPAsupplicant conf?
It is located at /etc/wpa_supplicant/wpa_supplicant. conf .
What is MotionEyeOS?
MotionEyeOS, a free open-source application, allows you to turn a Raspberry Pi with a camera into a home video monitoring system, where the photos and videos can either stay on your device (and home network) or, if you choose, be uploaded automatically to a cloud-storage service such as Google Drive or Dropbox.
Where are MotionEye logs?
Use a terminal on your host to gain ssh access and check the log at /var/log/motioneye. log: You should now have a fully functioning motion activated surveillance system that will automatically upload any video files to your Google Drive where you can access them from any device.
How do I install MotionEye on Raspberry Pi?
Booting MotionEye on Raspberry Pi
- Insert the microSD card in the Raspberry Pi;
- Connect an Ethernet cable – this is needed on the first boot;
- Connect a camera.
- Apply power to your Pi, and wait for about 2 minutes for the system to be ready.
What is the use of WPA supplicant?
Supplicant is the IEEE 802.1X/WPA component that is used in the client stations. It implements key negotiation with a WPA Authenticator and it controls the roaming and IEEE 802.11 authentication/association of the wlan driver.
Can you install motionEye on Raspbian?
You’ll install MotionEyeOS on a microSD card and then, insert the microSD card into your Raspberry Pi board.