Contents
How do I continue a failed print?
STEP 1: Locate the layer height to resume the print from and delete the entire g-code before that layer. STEP 2: Make sure the bed and extruder temperatures are set to the correct values on the printer. STEP 3: Save the g-code file and print it to resume your print from Z.
Why does my 3D print keep failing?
Typically this 3D printing problem is attributable to two parts of the printing process — either something is wrong with your filament supply, or there’s a problem with the hot end/nozzle itself. Or it could be too tight of an idler on your extruder resulting in stripped filament that isn’t being fed into the hot end.
Do you have to level the bed every time you print?
How often should you level your 3D printer? Once it is leveled for a certain filament, you only need to make small adjustments every 5 to 10 prints. If you change the temperature or move the hot end at all, you may want to reconsider leveling again.
Why did my print mess up?
Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. The best ways to prevent over extrusion are: Make sure you layer height is less than your nozzle diameter. Increase your cooling fan’s power (this will cool the plastic and cause it to slow down)
How often should you level your bed?
You can get away with leveling the bed every 5-10 prints depending on how stable the bed is and how careful you are when removing the finished prints from the surface. In order to stay on the safe side, it is advisable to level the bed before a large print (15 hours or longer) to ensure that it doesn’t fail mid-print.
Where do I find mesh bed leveling settings?
The Mesh bed leveling settings can be found within Settings – Mesh bed Leveling, on the LCD menu. There you have the following options: Mesh: The default grid-density is 3×3 (9 points). However, if you still experience uneven first layer adhesion, you can increase the density in Settings – Mesh bed leveling – Mesh to 7×7 (49 points). Z-probe nr.:
How do I reset my bed leveling settings?
You have to use M500 to save the bed leveling data to EEPROM, otherwise the data will be lost when you restart (or reconnect) the printer. Use M502 to reset the bed leveling data (and other settings to defaults). Use M501 to reload your last-saved bed leveling from EEPROM. This is done automatically on reboot.
Do you need to enable auto bed leveling on Marlin?
Unless you know you have a very flat bed, you should always use AUTO_BED_LEVELING_BILINEAR. And if you have an LCD and enough program memory, you should also enable LCD_BED_LEVELING to add a Bed Leveling sub-menu to the LCD. Configure the points (for 3-point leveling) or boundaries (for the others) where probing will occur.
How does mesh bed leveling work on Prusa?
During printing, if the bed is slightly warped, the sensor will still precisely follow the surface according to its measured mesh. This procedure is performed before every print. It is also the same procedure that happens in the second round of XYZ-calibration. The StallGuard for the Z-axis is active during the mesh bed leveling.