How do I debug a community user?

How do I debug a community user?

How to set debug log for Community Guest User?

1. Go to Domains.
2. Select the URL of Community.
3. Select the Community.
4. Click Public Access Settings button.
5. Click Assigned Users. Get the username.
6. Go to Debug Logs.
7. Click New and select the user.
8. If you are in chrome execute the below command in the console. document.

How do I set debug logs for Community user in Salesforce?

Set a user-based trace flag on the guest user.

1. From Setup, enter Debug Logs in the Quick Find box, then click Debug Logs.
2. Click New.
3. Set the traced entity type to User.
4. Open the lookup for the Traced Entity Name field, and then find and select your guest user.
5. Assign a debug level to your trace flag.
6. Click Save.

How do I use debug mode in Salesforce?

Enable Debug Mode in Salesforce

1. In Salesforce, from Setup, enter Debug Mode in the Quick Find box, then select Debug Mode Users.
2. Click Enable.

How to set Debug log for community guest user?

1. Go to Domains. 2. Select the URL of Community 3. Select the Community. 4. Click Public Access Settings button. 5. Click Assigned Users. Get the username. 6. Go to Debug Logs. 7. Click New and select the user. 8. If you are in chrome execute the below command in the console. 9. You will start seeing debug logs for the community guest user.

Where do I find the debug programs user right?

Navigate to Local Computer Policy >> Computer Configuration >> Windows Settings >> Security Settings >> Local Policies >> User Rights Assignment. If any accounts or groups other than the following are granted the “Debug programs” user right, this is a finding. If an application requires this user right, this would not be a finding.

How to add a user to ” debug Users ” Group?

1) Run GPEDIT.MSC from command prompt. Local Computer Policy à Computer Configuration à Windows Settings à Security Settings à Local Policies à User Right Assignment à Debug programs and add users to it. You should also be aware of If you grant somebody SeDebugPrivilege, you gave away the farm

How to enable MS Access VBA debugging?

Go to Tools>Startup>Advanced>Special Keys and make sure breakpoints aren’t turned off. If that’s not the issue try exporting the module/form, removing it, then re-importing it. The fact is there are break points, and the ability to step through code line-by-line, and to check the call stack and everything else.