How do I delete a port VLAN?

How do I delete a port VLAN?

Removing VLANs from a physical port

1. From global configuration mode, enter interface Ethernet configuration mode. device(config)# interface ethernet 1/1/1.
2. Enter the remove-vlan all command to remove all VLANs from the Ethernet port. Enter the remove-vlan vlan command to remove the VLANs from the Ethernet port.

How do I clear the configuration on an HP switch?

Solution:

1. Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch. The power and fault lights come on.
2. Continue to press the Clear button while releasing the Reset button.
3. When the Self Test LED begins to blink, release the Clear button.

How do I change the ipv4 Layer 3 address?

Configuring the Layer 3 Interfaces

1. Navigate to the Distribution Switch’s details page from Monitor > Switches.
2. Click Initialize layer 3 under the Status section.
3. Enter the following settings: Name: Uplink. Subnet: 192.168. 128.0/24. Interface IP: 192.168. 128.1. VLAN: 20. Default Gateway: 192.168. 128.254.
4. Click Save.

What is the command to reset a switch?

Reset the switch to factory defaults:

1. Erase the existing configuration: write erase.
2. Reload the switch software: reload.
3. In the configuration wizard, enter the basic switch settings: Admin password.
4. When prompted, enter the user name and password to log in to the switch.

How do you delete an interface?

Deleting network interfaces

1. Click the Network tab.
2. In the Network Interfaces tab, select the interface that you want to delete, and then click Delete.
3. Select the confirmation check box, and then click Delete.

How do I allow a specific vlan on a trunk port?

By default, a trunk interface can carry traffic for all VLANs. To specify that only certain VLANs are allowed on the specified trunk, use the switchport trunk allowed vlan command. If you do not configure this parameter, the trunk port uses the default VLAN as the native VLAN ID.

How to configure layer 3 switches with no switchport?

The no switchport command makes the interface Layer 3 capable. The IP address is in the same subnet as the default router. Note: This step can be omitted if the switch reaches the default router through a VLAN. In its place, configure an IP address for that VLAN interface.

How can I erase the L3 switch configuration?

If you have an older version of the OS you will need to use the undo command and negate the previous settings as the other guys mentioned. Hope this helps you on your quest. actually I’ve got HP switches 2600 series and after writing “erase” and clicking “tab” button I see choices which I can make: erase config, flash, or start-up config.

How to configure layer 3 port channel with subinterfaces?

Hi I am trying to figure out how to configure Layer 3 port-channel with subinterfaces. This is my topology. Two physical interfaces will be bundled into a single port-channel. My CSR will act as a “Router On A Stick”. All interfaces on the switch are trunk port, allowing all vlans.

How to use VLAN routing with Layer 3 switch?

VLAN Routing with Layer 3 Switch Routed Ports 1 Stripping off the incoming frame’s Ethernet data-link header/trailer 2 Making a Layer 3 forwarding decision by comparing the destination IP address to the IP routing table 3 Adding a new Ethernet data-link header/trailer to the packet 4 Forwarding the packet, encapsulated in a new frame