How do I disable the reed on my laptop?

How do I disable the reed on my laptop?

Method 1 (easy)

  1. Click the Start (Windows) button.
  2. type “Power Options” and press enter.
  3. In the left hand pane, click “Choose what closing the lid does”
  4. Under “When I close the lid:” select “Do nothing” (you can do this for on battery, plugged in, or both)
  5. Click “Save Changes”

Can reed switch go bad?

what is a failure? Reed switches or relays eventually fail in one of three ways . They do not open when they should (usually called “sticking”), they fail to close when they should (“missing”), or their static contact resistance gradually drifts up to an unacceptable level .

How do you close a reed switch?

reed switch and sensor. Recall that the natural state of a form A reed switch is normally open. It can be turned into a normally closed switch by applying a permanent magnet with a field strong enough to close the reed contacts.

How does a normally closed reed switch work?

You can also get reed switches that work the opposite way: the two contacts are normally snapped together and when you bring a magnet up to the switch, spring apart. Reed switches like this are called normally closed (NC) (normally switched on), so electricity flows through them most of the time.

Why are reed switches made of metal contacts?

Reed switches are made of metal contacts that have been annealed, a process that leaves no or very little magnetic retentivity. This means after the reed switch is removed from a magnetic field, there should not be any residual magnetism in the contacts.

What causes a sensor reed switch to stick?

Reed switches can stick for the following reasons: The metal of the contacts have been pitted or otherwise compromised, from arcing if switching with active loads. The contacts have become magnetized (or another magnetic field is unaccounted for) The reed switch is physically damaged, such as through bending or cutting the leads improperly.

Why do reed switches have no magnetic retentivity?

Reed switches are made of metal contacts that have been annealed, a process that leaves no or very little magnetic retentivity. This means after the reed switch is removed from a magnetic field, there should not be any residual magnetism in the contacts. ( Meder)