Contents
How do I disconnect JST connector from logic board?
To disconnect them, use a black stick and your finger to help support the cables and keep the connectors level. To connect the cables and avoid damage to the sensitive contacts in the JST connectors, make sure the mated parts are completely aligned, level, and flush to each other before applying pressure.
How do I disconnect a Molex connector?
To disconnect a Molex connector (male and female connection), simple press down on outside clip and pull the connectors apart. The power connectors have hooks that allow the connectors to latch into the connector housing. Once the crimped wire has been inserted into the housing, it will be difficult to remove.
How do you remove a closed end crimp connector?
In most cases, connectors either hold the wire in with a small metal prong or they are crushed onto the wire. With a gentle tug, the wire usually pulls out of the connector. Place a pair of wire cutters next to the connector and cut the wire to remove it from the connector.
How do you disconnect a cable from a socket?
Place the tip of your tool under the edge of the connector, and pry the connector straight up from its socket. Be very careful to pry only under the edge of the connector, and not under the socket itself.
How does a wire to board connector work?
This type of device connects a wire to a printed circuit board (PCB), enabling connectivity between circuits. A wire-to-board connector connects a wire to a printed circuit board (PCB), enabling connectivity between circuits.
How do you separate the LCD from the circuit board?
Screws or twisted metal tabs commonly secure a metal frame, which compresses the elastomeric strip between the LCD and the circuit board. Release these to separate the LCD and the elastomeric strip. In the photo, bright light reveals the conductive traces on the glass of the LCD.
What’s the best way to reconnect a cable?
If you pry under the socket, you will separate it from the circuit board, which requires specialized microsoldering skills and equipment to repair. To reconnect, align the connector carefully over its socket and press down with your fingertip—first at one side, then the other—until it clicks into place.