How do I enable DHCP option 60?

How do I enable DHCP option 60?

Adding DHCP option 60 to Windows 2003 DHCP server

1. Open a command window (select Start > Run > cmd)
2. Type netsh.
3. Type dhcp.
4. Type server \\ or server
5. You then see a command prompt that says: dhcp server>
6. Type add optiondef 60 PXEClient STRING 0 comment=option added for PXE support.

How configure DHCP in Cisco IOS?

When you’re looking to configure DHCP on Cisco routers, Layer 3 and Layer 2 switches, follow these steps:

1. Exclude IP addresses from being assigned by DHCP.
2. Create a new DHCP pool.
3. Define a subnet that will be used to assign IP addresses to hosts.
4. Define the default gateway.
5. Define the DNS server.
6. Define the DNS domain name.

How do I set DHCP options?

Configuring DHCP Options

1. Navigate to Security & SD-WAN > Configure > DHCP (or, on the MS switch, Switch > Configure > Routing & DHCP > [the interface being edited] > DHCP settings)
2. Select Add a DHCP option.
3. Select the desired Option from the list or if it isn’t listed, add a custom option.
4. Input the DHCP Code.

What is Option 150 and Option 66 in DHCP?

DHCP option 150 provides the IP addresses of a list of TFTP servers. DHCP option 66 gives the IP address or the hostname of a single TFTP server.

What is option 66 used for?

Option 66 is a DHCP option, configured in your DHCP server (usually the router), that, upon obtaining an IP address, devices set with Option 66 enabled will also receive the address of a provisioning server, where they will immediately attempt to autoprovision.

What is DHCP Option 150 where is it used?

When a Cisco IP Phone starts, if it does not have both the IP address and TFTP server IP address pre configured, it sends a request with option 150 to the DHCP server to obtain this information. DHCP Option 150 is Cisco proprietary. Like option 150, option 66 is used to specify the Name of the TFTP server.

When to use Option 60 in DHCP scope?

Option 60 is used by DHCP clients (LAPs in this case) in order to identify itself to the DHCP server. When we define an option 60 in our DHCP scope in combination with the option 43, We instruct the DHCP server to return the content of option 43 only to those clients that present the right option 60 i.e already configured VCI in…

How to add option 60 to ISC DHCP server?

If you are using the ISC DHCP server 2.0, you can add the DHCP option 60 to a group of targets or to a single target by adding the statement option dhcp-class-identifier “PXEClient”; to a section of the configuration file.

Where is option 43 defined on the DHCP server?

On the DHCP server , option 43 is defined in each DHCP pool (Scope) that offers IP address to the LAPs.So the idea is that do not send the content of option 43 to clients that do not need it and we defined the clients using VCI in option 60. Do we need option 60?

How to send different DHCP options to different devices?

In several meetings I get the question, how can I sent different DHCP options to different devices. The answer is to use the DHCP Vendor Class Identifier, DHCP option 60. Every device sends this option to the DHCP Server, and each DHCP Server can answer with specific options, depending on the option 60.