Contents
How do I enable Kprobe?
Enable the kprobe.
- Set the value of /sys/kernel/debug/tracing/events/kprobes/doforkprobe/enable to 1. # echo 1 > /sys/kernel/debug/tracing/events/kprobes/doforkprobe/enable. There will now be some capture counts in .
- Review the capture counts. # root@root:/sys/kernel/debug/tracing> cat kprobe_profile.
What is a kprobe?
There are two types of probes in the kernel as of now, called “KProbes” and “JProbes.” A KProbe is defined by a pre-handler and a post-handler. When a KProbe is installed at a particular instruction and that instruction is executed, the pre-handler is executed just before the execution of the probed instruction.
How kprobes work?
kprobes (kernel probes) is Linux kernel mechanism for dynamic tracing. It allows you to insert breakpoint at almost any kernel function, invoke your handler and then continue executing. It works by runtime patching kernel image with so-called kernel probe/kprobe – see struct kprobe .
What is a kernel probe?
Kernel probes are a set of tools to collect Linux kernel debugging and performance information. Developers and system administrators usually use them either to debug the kernel, or to find system performance bottlenecks. The reported data can then be used to tune the system for better performance.
What is Pt_regs?
pt_regs is at the high end of kernel stack, is mainly used for saving user registers in user-kernel mode switching. Therefore, after returning to user space, the first instruction get executed is at pt_regs->pc . cpu_context is in task_struct->thread_struct, is mainly used for saving registers of context switch.
What is driver probe function?
The kernel then calls the driver’s probe() function once for each device. This probe function starts the per-device initialization: initializing hardware, allocating resources, and registering the device with the kernel as a block or network device or whatever it is.
How do I enable ftrace?
Enabling ftrace events
- Set the buffer size to a value large enough for your trace: echo 96000 > /d/tracing/buffer_size_kb.
- Enable tracing: echo 1 > /d/tracing/tracing_on.
- Run your test, then disable tracing: echo 0 > /d/tracing/tracing_on.
- Dump the trace: cat /d/tracing/trace > /data/local/tmp/trace_output.
When does kprobes pass control to Kprobe handler?
When a CPU hits the breakpoint instruction, a trap occurs, the CPU’s registers are saved, and control passes to Kprobes via the notifier_call_chain mechanism. Kprobes executes the “pre_handler” associated with the kprobe, passing the handler the addresses of the kprobe struct and the saved registers.
How does kprobes work in the Linux kernel?
Kprobes enables you to dynamically break into any kernel routine and collect debugging and performance information non-disruptively. You can trap at almost any kernel code address 1, specifying a handler routine to be invoked when the breakpoint is hit. 1 some parts of the kernel code can not be trapped, see Blacklist)
When does kprobes make a copy of the probed instruction?
When a kprobe is registered, Kprobes makes a copy of the probed instruction and replaces the first byte (s) of the probed instruction with a breakpoint instruction (e.g., int3 on i386 and x86_64).
What is the difference between Kprobe and kretprobe?
There are currently two types of probes: kprobes, and kretprobes (also called return probes). A kprobe can be inserted on virtually any instruction in the kernel. A return probe fires when a specified function returns. In the typical case, Kprobes-based instrumentation is packaged as a kernel module.