How do I flash my eMMC BeagleBone black?

How do I flash my eMMC BeagleBone black?

Hold the “User Boot” button down, and then plug in the power (USB or 5V adaptor). Keep holding down the button until you see the bank of 4 LED’s light up for a few seconds. You can now release the button. It will take anywhere from 30-45 minutes to flash the image onto the on-board chip.

What is the boot source order if S2 button is pressed during powering up of the BBB board?

The normal sequence is (S2 button not pushed): MC1 (eMMC on-board flash), MMC0 (SD card), UART0, USB0.

How do you make a BeagleBone black picture?

Code

1. Depends.
2. Clone the Yocto Repo.
3. Clone OpenEmbedded repo.
4. Clone the Beaglebone Black Repo.
5. Initialize the build directory.
6. Partition the sd card.
7. Minimal rootfs instructions – Install device tree files and kernel uImage to rootfs/boot.
8. Run the build.

How do I connect my BeagleBone Black to WIFI?

How to Configure the Wifi on a BeagleBone Black Wireless

1. Connect to the BBW.
2. Run the network manager: debian@beaglebone:~$ sudo connmanctl.
3. Enable Wifi: connmanctl> enable wifi.
4. Scan for Wifi networks: connmanctl> scan wifi.
5. Show available Wifi services: connmanctl> services.
6. Turn on the agent: connmanctl> agent on.

How do I find the IP address of my BeagleBone Black?

Connect a monitor or TV to the HDMI output on the board. At the command prompt, enter ifconfig . When the board is connected to the host computer using the USB cable (the default configuration), the usb0 configuration describes the connection. The inet parameter on the second line shows the IP address of the board.

How long does it take to flash eMMC from SD card?

Wait until the LEDs stop blinking and all 4 LEDs are fully lit (the latest image then powers the board down). This process can take 5-25 minutes depending on the image used.

How can I Flash my Micro SD card on my BBB?

Power off your BBB by physically disconnecting the USB/power cable. Plug the micro-SD card into the BBB’s micro-SD card slot. Hold the Boot Button (S2) on the top right (near the SD card slot) and, while holding this button, insert the USB/power lead to connect the power. Keep holding the button until the LEDs start to flash.

How to flash eMMC from SD card BeagleBone Black?

Wait for the lights to all be steady and stay lit. That means that the flash was completed. Power down the beagle bone, by holding the power button for 10s. And viola! Push the power button, and the new Debian Stretch v9.1 Should boot up in about 1 min.

What to do if your micro SD card does not flash?

If the flashing procedure fails—for example, no LEDs flash, or it keeps running for more than 45 minutes —then disconnect the power and try restarting the BBB with the S2 button pressed. Remove the micro-SD card. This is important, as you could end up flashing the eMMC again by accident.