Contents
How do I get rid of Airwires in Eagle?
Connect them to vias, define a power plane with the correct name and hit “ratsnest” and they should disappear.
What is Eagle Air wire?
The RATSNEST command also calculates all Polygons belonging to a signal. Note that RATSNEST doesn’t mark the board drawing as modified, since the calculated polygon data (if any) is not stored in the board, and the recalculated airwires don’t really constitute a modification of the drawing.
What is the meaning of DRC in Eagle software?
The command DRC checks a board against the current set of Design Rules. If two coordinates are given in the DRC command (or if the Select button is clicked in the Design Rules dialog) all checks will be performed solely in the defined rectangle. Only errors that occur (at least partly) in this area will be reported.
How many air wires are left in Eagle?
But Eagle says I have 23 air wires left. It turns out they are little tiny ones, e.g. where traces overlap, like this one: There is a tiny yellow dot where the two traces overlap pointed to by the arrow. Is there a way to join these traces together to eliminate this? Or do I have to delete one trace, and extend the other one?
How can I hide airwires in my Eagle?
Instead of using ratsnest ! signal_name, you can use the info command on a signal (airwire or trace) in the board window and you will see a check box “Airwires hidden” for that signal in the popup “Properties” window. Click on it and all airwires for that signal will be gone. and look for “hide-airwires.ulp”.
How to find air wires in EAGLE PCB?
You’ll probably see the line then. I think that the fastest option is to select the Edit->Route and click with the left button of the mouse on the board. Automatically eagle will draw a track to the nearest untracked wire of the board (or to the latest unrouted wire, do not worry).
What to do if ripup makes whole route an AirWire?
If the ripup tools makes the whole route an airwire, you need to use the backspace to go back one click. Then try to land to the center of the pad. I found several little air wires on my layout and worked out that they were actually representing connections between layers.