How do I know if VLAN is enabled?
Use the show vlan command to verify your VLAN configuration. This command displays all switchports and their associated VLAN as well as the VLAN status and some extra parameters that relate to Token Ring and FDDI trunks. You can use the show vlan id [vlan#] command to see information about a particular VLAN.
How do I find the VLAN on a Cisco switch?
The show vlans command lists the VLANs currently running in the switch, with VID, VLAN name and VLAN status. Dynamic VLANs appear only if the switch is running with GVRP enabled and one or more ports has dynamically joined an advertised VLAN. In the default configuration, GVRP is disabled.
When to use show interface command in Cisco NCS 5500?
We recommend that if your Cisco NCS 5500 and Cisco 540 Series Router has a value below 10 milliseconds, reconfigure the value to a minimum of 10 milliseconds, and if required assign a higher value. Note Enter the show interface command to see the current state of the carrier-delay operation for an interface.
What is the default VLAN range in Cisco NX OS?
To return to the default block of reserved VLANs (3968 to 4094), you must enter the no system reserve vlan command. The write-erase procedure does not restore the default reserved VLAN range to 3968 to 4094. Beginning with Cisco NX-OS Release 5.1 (1) , you can configure a VLAN without actually creating the VLAN.
How to configure Cisco Nexus 7000 NX-OS interface?
See the Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x for complete information on configuring VLAN interfaces, and subinterfaces, as well as assigning IP addresses. This feature must be enabled before you can configure VLAN interfaces.
Can you configure a Cisco VLAN without creating a VLAN?
Beginning with Cisco NX-OS Release 5.1 (1) , you can configure a VLAN without actually creating the VLAN. This procedure is used for IGMP snooping, VTP, and other configurations. By default, all Cisco NX-OS ports are Layer 3 ports.