Contents
How do I mount a partition using UUID?
First, find the UUID of the partition that you want to mount using one of the methods stated above. Let’s say, you want to mount the partition /dev/sdb1 using it’s UUID 7a75296d-412a-467c-a659-283298910746 to the path /var/www.
How to change the UUID of a hard drive in Linux?
Linux systems don’t mount hard drives, they mount filesystems that live inside partitions or logical volumes on those drives. In the case of ext2/ext3/ext4 filesystems, you can change the UUID using the tune2fs command. From man tune2fs: -U UUID Set the universally unique identifier (UUID) of the filesystem to UUID.
How to mount filesystems using the UUID directive?
When you mount a filesystem by UUID, the mount command will just look up the corresponding device name and using it for the actual mount operation, which you can confirm by looking at /proc/mounts: all mounted filesystems, whether they are mounted using block device names or LABEL= or UUID= directives, will be listed by device names.
Where do I find the UUID for my hard drive?
Editing /etc/fstab can tell the OS to automatically mount a drive during startup. This preferably uses UUID to identify the drive. The existing UUID can be found with blkid or by looking in a partition editor (gparted or equivalent).
What to do if disk by UUID is not detected?
Have a look at /etc/fstab and confirm the uuids there by issuing the blkid command for each device. Fix these entries as they’re important. This will create a fresh initramdisk for your version. If you don’t know the exact version you were running have a look at the files in /boot/. Picking the highest version number should be safe.
Why is my Ubuntu not recognizing the UUID?
I was able to fix it manually and now it boots OK, but every time it still shows errors about missing blkid. Also, boot failure re-appears after updates that require rebooting. The UUID in the /proc/cmdline is correct, however system fails to recognize it.
When to use UUID and label in Linux?
LABEL on the other hand is a short name that you can put it when you format a partition to identify the disk. Many people can use the same LABEL. So, the uniqueness of LABEL depends on how creative you are at naming your partitions. In this article, I will show you how to mount partitions using UUID and LABEL using the /etc/fstab file on Linux.
How to get UUID of device in Ubuntu?
To probe filesystem type and read label and uuid for /dev/sdb2 (or any other device) use vol_id command: # vol_id –uuid {/dev/device}.
How to insert UUID into Vim mount command?
This involved, either copying the UUID, when possible, or typing it manually. Which is obvious error-prone . inside the mount command, as follows: Additional: When using vim one could use :r (ead)! from command mode, when editing /etc/fstab, for example, to insert UUID into file. Note: Swap all occurrences of /dev/vda1 and /mnt for your own values.
What happens if you use UUID instead of label?
Depending on the order of how you connected the hard drives to your motherboard, it may change. If that happens, your hard drives may be mounted in the wrong mount points resulting data loss or data corruption. To solve this, we can use UUID or LABEL.