How do I ping another router?
To send the router a friendly ping, follow these steps:
- From the Start menu, choose All Programs→Accessories→Command Prompt.
- To discover the router’s address, type ipconfig and press Enter.
- Type the command ping, a space, and then the IP address of the router, or default gateway; press Enter.
Can you ping the other network without using router in the path?
as we know that we can’t ping computer which is in the other Network without routing protocol. That is incorrect. Routing protocols are one of three ways routers populate their routing tables: Directly connected networks.
What router interface is the next hop for network?
You need to specify only the output interface (the interface on which all packets are sent to the destination network) in a directly connected static route. The router assumes the destination is directly attached to the output interface and the packet destination is used as the next hop address.
Which parameter does the router?
If there is a route for the destination network in the routing table, the router forwards the packet using that information. If there are two or more possible routes to the same destination, the metric is used to decide which route appears on the routing table. The lower the metric, the better the route.
Why is switch can’t Ping directly connected router?
Not quite sure what is going on here go 3 issues. 1. So the Interconnect Sw Primary is not able to ping the directly connected InterRt Primary. 2. Access Sw 1 can’t ping any other sub intefaces on directly connected router, but can ping designated mgmt sub interface which is the 0.0.0.0 route.
Do you need to specify next hop IP address for static routes?
Cisco recommends that you configure both the outbound interface and the next hop address for a static route. In the case of a serial interface, the specification of the outbound interface is sufficient because a serial interface is a point-to-point interface.
Do you need to specify the next hop address?
You can specify the directly connected next hop address only, but this is not recommended for reasons that are described in this document. You do not need to specify the directly connected next hop address. You can specify the remote next hop address and the interface to which the remote next hop recurses.
Can You Ping from one router to another VLAN?
I have 5 VLANS (5, 10, 20, 50 [NATIVE] and 99) that all meet at a common gateway where they all communicate together fine. The same router is connected to another router, representing ISP provider. From inside my LAN I can ping to any of the VLAN gateways. I can even ping to the other side of my LAN router.