How do I run Apache on two ports?
Configure Apache Web Site to Use Multiple Ports
- Context: In my example, I ran Apache on Port 80 on a single IP.
- Step 1: Open Apache configuration File httpd.conf (on my windows host, it’s located here: “c:\Program Files\Apache Group\Apache2\conf”)
- Step 2: Find the line: Listen 80 and Type Listen 8080 on the next line:
How do I configure multiple instances of Apache httpd on the same server?
Configure Multiple Instances of Apache (HTTPD) on Same Server
- Duplicate the Http Configuration File.
- Duplicate the conf.d location.
- Change the PID file Name, Listen port number and include the conf.d2 location.
- Start the Second Instance using.
- Start the First Instance using.
What port is Apache listening on?
port 80
By default, Apache web server is instructed to listen for incoming connection and bind on port 80. If you opt for the TLS configuration, the server will listen for secure connections on port 443.
Can two Apaches run on same machine?
As mentioned before, note that only one local installation is required to run multiple instances of apache. Note also, that there are other alternative ports in FreeBSD that will install different flavours of Apache https: www/apache22-event-mpm. www/apache22-peruser-mpm.
Is there a way to configure the https binding for each website?
I know I have to configure the https binding for each site on a different port, but is there a way to do this so the port does not have to be specified when accessing the website, and so it works on restricted networks that only allow port 443 traffic?
How to configure Apache web site to use multiple ports?
Step 3: Find the VirtualHost portion for your Website config and Add *:8080 as shown below: Note, your config file might not look exactly like mine. Instead of *:80 you might see an IP address:80 – it depends, but this should give you the general idea.
How does binding work in Apache HTTP Server?
When httpd starts, it binds to some port and address on the local machine and waits for incoming requests. By default, it listens to all addresses on the machine. However, it may need to be told to listen on specific ports, or only on selected addresses, or a combination of both.
How to bind to IP address and Port?
If an IP address is given as well as a port, the server will listen on the given port and interface. Multiple Listendirectives may be used to specify a number of addresses and ports to listen on. The server will respond to requests from any of the listed addresses and ports.