Contents
How do I use my x32 as an audio interface?
Open the ROUTING menu, select the CARD OUT tab, and select new sound sources for the card’s output channels.
- Connect the X32 to your computer via USB.
- Launch your DAW and select the X32 as the audio input/output device.
- Create tracks in your DAW and assign each input to the correct input channel.
What is output routing?
Output routing. The Output Routing window is where you assign your inputs and outputs to different sources. You can also adjust the panning and signal level of individual inputs and outputs. It’s comprised of three separate sections — Hardware Inputs, Software (DAW) Playback, and Outputs.
How do I connect my AES50?
Using a shielded Cat5-e ethernet cable, connect the S16’s AES50-A jack to your X32’s AES50-A port. On the X32, press the SETUP button and go the global page. Use ENCODER 2 to choose a sample rate and then select INTERNAL Synchronization. Press the Routing button and assign the AES50 inputs to the X32 channels.
How do I set up my X32?
Connect your device to the wireless network and launch the X32 Mix (iPad) or Edit (PC/Mac) app.
- X32 Mix: Upon launch, enter the X32’s IP address and press CONNECT.
- X32 Edit: Click SETUP and select the Connection tab. Click RESCAN, select the X32, and then click CONNECT.
Does the Behringer X32 have Bluetooth?
Obvious”, but it is easy to add Bluetooth streaming to most of the X32 mixers. You can scrounge around for the right cables, but most of these devices support Bluetooth.
How to select sound source in Behringer X32?
Rotate and press ENCODER 1 to select the Analog Output. Rotate and press ENCODER 3 to select the Category and ENCODER 4 to select the specific sound source (main or bus mix, direct-out, etc.) and Tap point.
What are the audio levels on the x32?
The two most common is -10dB and +4dB, either way the X32 aux inputs and the XLR inputs have plenty of channel gain adjustment to accommodate for either level. One thing to keep track of is if you hear a buzz on the channel when you solo it.
How can I connect my X32 to my computer?
Another way to connect computer audio to the X32 is utilizing the USB card on the console, if your console has one. This effectively make the X32 a USB audio device on the host computer. We run a USB cable from our ProPresenter computer to the X32 and route the USB card audio to on of the AUX channels.
What kind of inputs does the x32 rack have?
The X32 RACK console features 16 analog rear-panel XLR inputs with microphone preamps, as well as 8 rear-panel XLR Outputs and 6 TRS Aux Sends and Returns. In addition, there are two AES50 ports, each featuring 48 input and output channels, and a card slot for 32 channels of input and output to and from a connected computer via USB 2.0.