Contents
How do I use Wvdial?
Dial On Demand with WVDial
- Install wvdial and pppd. The first step is to download and install wvdial and pppd.
- Setup wvdial to dial your ISP.
- Change wvdial to be used as a chat replacement.
- Edit the peers file to run with dial-on-demand.
How do I install Wvdial?
In LiveCD, just command sudo apt-get install wvdial and you install it completely without internet. Yes, Linux Mint has same behavior too. It is probably a secret only few people know. To install it, just insert your Ubuntu CD (same version, same architecture) and command apt-cdrom it to be your additional repository.
Should I enable adaptivity?
It allows you to get greater better signal strength, and thus better throughput, at range. You want it on for both VHT and HT. “Adaptivity” seems to relate to ETSI’s (European Technology Standards Institute’s) adaptive frequency hopping requirements which are mostly for Bluetooth.
How to setup a USB 3G modem using USB _ modeswitch?
Open a terminal window and enter the following replacing the codes 19d2 and 2000 with the codes you noted in step 2. Also note the added backslash. Now open the extracted file with a text editor like leafpad replacing the codes noted in step 2. The content of the file should look something similar to the screenshot below.
How to setup a USB 3G modem on Raspberry Pi?
1. Install required software Connect your Raspberry PI to the internet via LAN or Wifi 2. Get the USB switching codes We need to get the codes of the USB device in USB storage mode and USB modem mode. The output will look similar to the screenshot below. Your modem should be listed as one of the USB devices.
Where does the modem go on a rapberry Pi?
Your modem should be listed as one of the USB devices. Note the numbers underlined. These are the device vendor and product codes. Make a note of these numbers. In this case it is 19d2:2000 Then we need to soft reboot the Rapberry PI with the modem connected.