Contents [hide]
- 1 How do you Bluetooth a dual CD player?
- 2 What is the orange wire that connects to the stereo to the amp?
- 3 How do I reset my dual media player?
- 4 Where do you wire an amp to turn on?
- 5 Can a CD player connect to a receiver?
- 6 How to connect a portable audio player to a stereo system?
- 7 How can I connect my RCA to my stereo?
How do you Bluetooth a dual CD player?
- To pair a Bluetooth enabled mobile phone to your head unit, change to Bluetooth mode.
- Press and hold on the head unit for 5 seconds, until “PAIRING” is displayed, the.
- Complete the pairing from the Bluetooth menu of your mobile device by searching.
What is the orange wire that connects to the stereo to the amp?
The normal use of orange and orange/white wires is orange is for variable voltage to control display illumination dimming (i.e. the head unit display dims along with the other dash lights) while orange/white is a simple on/off signal of whether the dash lights are on (the head unit has only bright and dim display …
What is the brown mute wire for?
The “MUTE” wire will attenuate the sound of the head-unit when triggered (12Volts) from an “External Source” ( e.g. Separate Bluetooth unit).
How do I reset my dual media player?
Press the RESET button to reset the unit back to the factory settings if abnormal operation occurs. The reset button is located on the front panel. With the unit on, press DISP to display clock time. Press and hold DISP until the hours begins to flash, then release.
Where do you wire an amp to turn on?
The turn-on wire (also called the remote wire) is located behind the stereo. On aftermarket stereos, it’s usually a blue and white wire. The remote wire will “tell” your amplifier to turn on whenever the stereo is powered up (usually, whenever the vehicle is turned on).
What does P cont wire mean?
#14 · May 12, 2019. I interpreted “p-cont” in your opening post to mean continuous power (non-switched). Looking at the diagram you posted, it shows that wire hooked up thru the ignition switch, which will provide switched power.
Can a CD player connect to a receiver?
I have a cd player I would like to connect to my receiver so I can listen to it with my new speakers and receiver setup. The only issue is, my CD player doesn’t have rca outputs, only the clips for the speaker wire attached to the included speakers.
How to connect a portable audio player to a stereo system?
On the stereo system, connect the audio cable to the LINE IN, AUX IN, or REC IN jack. If necessary, switch the stereo system to the corresponding LINE IN, AUX IN, or REC IN jack that the portable player is connected to.
Is there a way to hook up a stereo to a receiver?
Neither a proper speaker-wire-to-line-level adapter, nor cable from headphones jack to your receiver, would produce the best sound. Your stereo belongs to a bedroom, not next to a receiver with speakers.
How can I connect my RCA to my stereo?
Then, hacking your stereo is the only way – find the point of the schematic where analogue signal will go into volume control, and attach RCA line outputs there. If your stereo uses analogue volume control with a potentiometer, it should not be that hard.