How do you calculate Vo?

How do you calculate Vo?

Calculate your VO2 max using the following equation: VO2 = 132.853 – (0.0769 x weight in lb) – (0.3877 x age) + (6.315 x gender) – (3.2649 x walk time in minutes) – (0.156 x heart rate). If you are male, use the number 1, if you are female, use the number 0 for the calculation.

What is Vo in diode circuit?

The supply voltage is divided between the two resistances to give an output voltage Vo which is the voltage across R2. An important use of voltage dividers is to connect input transducers to circuits. If R2 is much smaller than R1, Vo is small (low, almost 0V) because most of the voltage is across R1.

How do you find BMI?

How to calculate Body Mass Index. Body Mass Index is a simple calculation using a person’s height and weight. The formula is BMI = kg/m2 where kg is a person’s weight in kilograms and m2 is their height in metres squared. A BMI of 25.0 or more is overweight, while the healthy range is 18.5 to 24.9.

What is Vo voltage?

The dc voltage at an output terminal with reference to a common terminal, normally ground, when no signal is applied to the input.

How do you test a diode in a circuit?

The Diode Test procedure is conducted as follows:

1. Make certain a) all power to the circuit is OFF and b) no voltage exists at the diode. Voltage may be present in the circuit due to charged capacitors.
2. Turn the dial (rotary switch) to Diode Test mode.
3. Connect the test leads to the diode.
4. Reverse the test leads.

How to determine the voltage of a series diode?

SERIES DIODE CONFIGURATIONS WITH DC INPUTS Determine I , V1 , V2 , and Vo for the series dc configuration of Fig. 2.27. Determine I D , V D2, and V o for the circuit . PARALLEL AND SERIES–PARALLEL CONFIGURATIONS Determine V o, I 1, ID1, and I D2 for the parallel diode configuration Determine the voltage Vo for the network

When is diode ” on ” then VO = VI-VC?

Example 4 When diode is “on” then Vo = Vdc When diode is “off” then Vo = Vi At –ve half cycle diode is “on” then Vo = Vdc At +ve half cycle there are two periods: (i) Vi Vdc then diode “off” and Vo = Vi CLAMPERS After the capacitor charged with Vc=+Vi then the diode is always “off” and Vo=Vi-Vc

How to determine the voltage VO for a network?

Determine the voltage Vo for the network Determine the currents I 1, I 2, and I D2 for the network AND/OR GATES Determine V o for the network of Fig. 2.38. Determine the output level for the positive logic AND gate of Fig. 2.41. SINUSOIDAL INPUTS; HALF-WAVE RECTIFICATION

Which is the ideal constant voltage drop model?

The Constant Voltage Drop (CVD) Model. Q: We know if significant positive current flows through a junction diode, the diode voltage will be some value near 0.7 V. Yet, the ideal diode model provides an approximate answer of v.