How do you configure routing on a Layer 3 switching?

How do you configure routing on a Layer 3 switching?

Step-by-Step Instructions

1. Enable routing on the switch with the ip routing command.
2. Make note of the VLANs that you want to route between.
3. Use the show vlan command in order to verify that the VLANs exist in the VLAN database.
4. Determine the IP addresses you want to assign to the VLAN interface on the switch.

How do I turn off Juniper interface?

– To Juniper disable interface:

1. root@Juniper# set interfaces ge-0/0/1.0 disable << This is cisco equivalent of “shutdown” – To Juniper enable interface:
2. root@Juniper# delete interfaces ge-0/0/1.0 disable << This is cisco equivalent of “no shutdown” Verification:
3. root@Juniper#show ge-0/0/1.0.

How do I set an IP address on a Juniper switch?

To configure a management port by CLI commands.

1. Use the command “family inet address” to configure a management IP address on the interface.
2. Configure a static route with the next hop to the management network default gateway set routing-options static route 0.0.0.0/0 next-hop 10.93.15.1/21.

How do I configure a Layer 3 switch?

Configuring the Layer 3 Interfaces

1. Navigate to the Distribution Switch’s details page from Monitor > Switches.
2. Click Initialize layer 3 under the Status section.
3. Enter the following settings: Name: Uplink. Subnet: 192.168. 128.0/24. Interface IP: 192.168. 128.1. VLAN: 20. Default Gateway: 192.168. 128.254.
4. Click Save.

What do Juniper Networks EX2200 Ethernet switches do?

Juniper Networks EX2200 Ethernet Switches provide connectivity for low-density environments. Support for Virtual Chassis—EX2200 switches support Virtual Chassis technology. You can interconnect up to four EX2200 switches to form a Virtual Chassis and manage and operate them as a single network entity.

Which is the default configuration for the EX2200 switch?

The number of interfaces in the default configuration file depends on the number of ports in the EX2200 switch. The poe stanza does not appear for models without PoE. Uplink ports for the EX2200 switches except the EX2200-C models will be listed as ge-0/1/0 to ge-0/1/3 and for the EX2200-C switches as ge-0/1/0 to ge-0/1/1.

How are EX series switches used in Layer 3?

EX-series switches use a routed VLAN interface (RVI) to perform these routing functions, using it to route data to other Layer 3 interfaces. This configuration example creates two IP subnets, one for v100 VLAN and the second for the v200 VLAN.

Which is juniper network switches support Junos OS?

The same Junos OS code base that runs on EX Series switches also runs on all Juniper Networks M Series, MX Series, and T Series routers and SRX Series Services Gateways. Juniper Networks EX2200 Ethernet Switches provide connectivity for low-density environments. Support for Virtual Chassis—EX2200 switches support Virtual Chassis technology.