How do you flatten a surface?

How do you flatten a surface?

To flatten a surface: In an open part, click Flatten (Surfaces toolbar) or Insert > Surface > Flatten. The Flatten PropertyManager displays. Select faces in the graphics area or from the FeatureManager design tree.

How do I flatten a surface in solidworks professional?

A Flatten-Surface feature appears in the FeatureManager design tree. You can move the Flatten-Surface feature using Move Body. Click Insert > Features > Move/Copy. You can use the Measure tool to check your flattened surface for accuracy.

Why is surface flatten greyed out?

The reason for the “Flatten” icon being greyed out was because the sheet metal part had a “Flat Pattern” annotation view and this annotation view was active. By selecting another annotation view, the “Flatten” icon then becomes available again.

How do you make a flat pattern in Solidworks?

To create a drawing of a flat pattern:

1. Open the sheet metal part for which you want to add a drawing.
2. Click Make Drawing from Part/Assembly.
3. Select a format or click OK to use the default format.
4. From the View Palette, drag the Flat pattern to the drawing sheet.
5. Click .

How much does exact flat cost?

You get a $19,980 value for $9,995 USD. (50% off) ExactFlat is fully featured and affordable 3D to 2D digital patterning software. Use it to create accurate 2D flat patterns from any 3D design in minutes.

What’s the best way to flatten a surface?

Very little loading is put into the parent metal, thus little deformation due to mechanical load or heat. There are three typical methods of surface grinding:. Reciprocating table, vertical spindle machines (think large cup wheel, or segmented), which are less common.

When does flatness apply to an outside surface?

Flatness can apply to either an outside surface of a part or a centerplane. When flatness applies to an outside surface, the feature control frame points at that surface or is on an extension line connected to that surface. The surface then, must fall between two parallel planes that in this case are 0.1mm apart.

Can a surface be flat relative to something else?

Something is either flat or not flat on its own. It is never flat relative to something else. Flatness can apply to either an outside surface of a part or a centerplane. When flatness applies to an outside surface, the feature control frame points at that surface or is on an extension line connected to that surface.

What’s the best way to flatten a cast iron surface?

Given equal machines and operator quality, the reciprocating table horizontal spindle would be best quality for a long flat surface. The grinding pattern is more appealing, being almost invisible, but parallel to the long dimension. However, it is slower, and hence generally more costly.