How do you increase line thickness in LTspice?
Thick Lines in LTSpice
- Open the control panel (tools menu bar)
- To thicken the schematic lines, Select the Drafting Options tab and check “Draft Thick Lines”
- To thicken simulation lines, Select the Waveforms tab and check “Plot data with thick lines”
How do I enable grid in LTspice?
To activate the grid mode, click on View and select command Show Grid. There are many buttons on the main menu for selection of basic circuit elements such as resistors, capacitors, inductors, diodes, wires, as well as a ground node (GND). The Ltspice IV’s Main toolbar is shown on Fig.
How to use the graph pane In LTspice?
Activate the graph pane, click “Pan”, and click the place you want to use as the reference of the display. (It is OK to activate the graph pane and click “View”-“Pan” on the menu bar.) As shown above, the point clicked with the mouse is the center of the vertical axis (Y-axis). Activate the graph pane and click “Zoom back”.
How to plot a parameter against something other than LTspice?
Open a new schematic in LTspice, insert LT3092 symbol by pressing the ‘F2’ function key and finish drawing the schematic and labeling the nets as follows. 2. Right click on the schematic and edit the simulation command to the following.
Where do I find waveform graph In LTspice?
Click “OK” after selecting the node name. The waveform graphs and node names of “V (output)” and “V (vin)” are displayed on the graph pane. In “Add trace”, the waveform can be displayed by selecting the node name in the same way as “Visible Traces”, and you can enter a calculation formula.
When to use LTspice in a transient analysis?
A common use for LTSpice ® is to run a time domain transient analysis where a parameter (e.g. voltage or current) can be plotted against time. Occasionally, you may wish to know the behavior of a circuit versus another parameter such as resistance.