Contents
How do you move via in Altium Designer 21?
To move a via without moving the connected tracks in the PCB Editor or PCB Library Editor, select the Edit » Move » Move command, then click, hold and move the via. If a via is being moved with the routing to create more routing or component space, it can be more efficient to re-route than move routing.
Why does Altium not drag and move traces?
I can’t drag/move traces or vias around once placed. It’s like alitum thinks there’s zero clearance available nearby to move too. (im using the free angle route placement mode, if this has anything to do with it. Cant use the usual 90/45 degree mode because this does not take grid angle into account)
Is there a problem with the Altium program?
Altium problem: Cant drag/move traces. Author Topic: Altium problem: Cant drag/move traces. (Read 8290 times) 0 Members and 1 Guest are viewing this topic. Altium problem: Cant drag/move traces. It’s a rigid flex design. The issue is on the sections of the pcb that have an angled grid. I can’t drag/move traces or vias around once placed.
How to turn a component green in Altium?
Normally the DRc would turn the component green. Here it doesn’t turn green it just block the move It is typically avoiding or blocking obstacles… Go to your DXP menu –> Preferences, expand “PCB Editor” in the left pane, and select “Interactive Routing”.
What are the different types of vias in Altium?
These are referred to as blind vias (from a surface layer to the next layer in) and buried vias (between two internal layers). Improvements in fabrication techniques and the introduction of laser drilling gave the ability to create very small (<10 mil) vias, formed from a surface layer to the next signal layer down. These are referred to as µVias.
How to calculate corner radius in Altium Designer?
Corner Radius (pad only) – percentage of pad corner that is rounded, where 100% completely rounds the shortest pad edge; only applies when Shape is Rounded Rectangle. Thermal Relief – thermal relief settings from this pad to a surrounding polygon of the same net, clear the From Rule checkbox to edit and use these local settings.
How is the template editor used in Altium?
The Template editor is used to configure the Pad or Via template currently selected in the Pad Via Library panel. The majority of Pad/Via configuration options are standard and familiar Altium Designer Pad and Via settings (Size, Hole and Mask, etc.).