How do you put a seal on a steering box?

How do you put a seal on a steering box?

Process

1. Disconnect the battery and lift the vehicle.
2. Remove the power steering gear from the car.
3. Clean the gearbox.
4. Remove the input shaft face cover.
5. Mark the cover and housing.
6. Remove bearing cap bolts and cover.
7. Pry the soft seal from the cap cover.
8. Drive the input shaft seal with a seal driver.

How do you change a pitman shaft seal?

Part 1 of 1: Replacing the pitman arm shaft seal

1. Materials Needed.
2. Step 1: Raise and secure the vehicle.
3. Step 2: Locate the steering box.
4. Step 3: Remove the retaining bolt from the pitman arm.
5. Step 4: Remove the pitman arm from the steering box.
6. Step 5: Remove the retaining ring.
7. Step 6: Remove the old seal.

What is a sector shaft on steering box?

The sector shaft is a critical component of an automotive power assisted recirculating ball steering gear and one that is vulnerable to fracture due to loads transmitted through the steering linkage under certain conditions.

What is a pitman arm seal?

The pitman arm is connected to the steering gearbox by a shaft seal. The seals are used to keep fluid running smoothly through the steering system. The pitman shaft seal can become worn down over time due to constant motion of the shaft. Once they wear down, they need to be replaced by a professional.

How do you replace the lower seal on a power steering box?

1. Step 1: Raise and secure the vehicle.
2. Step 2: Locate the steering box.
3. Step 3: Remove the retaining bolt from the pitman arm.
4. Step 4: Remove the pitman arm from the steering box.
5. Step 5: Remove the retaining ring.
6. Step 6: Remove the old seal.
7. Step 7: Install the new seal.
8. Step 9: Prepare to install the pitman arm.

Where is the steering gear sector seal located?

The steering gear sector shaft is located inside of the steering gear box, and turns the pitman arm when activated by the steering wheel. This causes the wheels to turn. The steering gear sector shaft seal keeps fluid from leaking out of the steering gear box.

How is the pitman arm secured to the steering box?

The bottom end is splined and threaded to hold the Pitman Arm in place and for the nut and washer that secure the Pitman Arm to the shaft. The steering box Housing has (in most cases) two needle bearings mounted inside it for the Sector Shaft to turn in.

When do you need a new steering shaft seal?

If you notice fluid leaking around the steering box, pitman arm, or sector shaft, check the steering gear sector shaft seal for damage. If you need replacement steering parts or seals, check out O’Reilly Auto Parts and find the right fit for your car, truck, or SUV.

Do you need a pitman arm shaft seal?

The fluid within the steering box must remain inside of the unit, despite the shaft being a potential source of leakage. For this, the pitman arm shaft seal is used.