Contents
How do you sand a concave surface?
Another great and cheap solution for sanding concave surfaces is using sponges. You can glue sandpaper with a piece of sponge and wrap around a cylindrical wooden or metal piece. This will let you sand some specific and small pieces where other solutions can’t reach easily.
How do you sand a tight corner?
Cut or fashion a 1/4-by-3/4-by-3-inch piece of wood into a long, sharp wedge. Fold the sandpaper over the sharp end and use it to sand inside tight corners. The wedge works similar to a surgical tool, allowing you to sand in short, focused strokes with some power behind them.
Which Sander would you use for inside curves?
A benchtop model will work almost as well. For convex curves, simply hold your piece flat on the table, and sand to your layout line, as shown in Photo C. For concave curves, the ideal tool to use is an oscillating spindle sander (Photo D).
Can cement be sanded?
You can sand concrete by hand and the right grit sandpaper will help you get the job done. Do not forget that when sanding concrete by hand, you will still need to mitigate the concrete dust produced. Keep your work area wet to keep the dust down and consider wearing a face mask or dust mask.
What’s the best way to sand a block of wood?
Follow up with a series of 5 or 6 full-length back-and-forth strokes, tilting the block over gradually with each stroke until the paper contacts the face of the work in the case of long-grain sanding. When sanding cross-grain, stop just shy of the surface, as shown at right.
What kind of tools do you need to sand wood?
Tools Required 1 Putty knife 2 Sanding block 3 Sanding grips
Which is the best Sander for wood removal?
Best Wood Sanding Tools. 1 1. Belt sander for fast wood removal. 1,554 Reviews Makita 9403 4″ X 24″ Belt Sander. 2 2. Random orbit sander – a must own wood sanding tool. 3 3. Palm sander finishing sanding tool. 4 4. Mouse sander for tight spots and detail wood sanding. 5 5. Drum sander.
What kind of backer do you use to sand wood?
A V-shaped sanding backer will ease both arrises of a panel edge at the same time. It’s great for fast chamfering or for aggressive roughing over of edges before following up with the rounding roll-over technique shown in section #2. A hardboard spline makes a great backer for reaching into grooves.