Contents
How do you solder a PL 259 plug?
Simple step by step instructions on how to fit a PL259 plug to coaxial cable.
- Step 1) Strip back the coax and pull back braid over cable.
- Step 2) Put outer part of plug onto cable then screw inner part over braid.
- Step 3) Solder end of the pin and trim excess wire.
- Step 4) It should look like this! Latest News.
Can coaxial cable be soldered?
Attaching RCA connectors can be a bit more time-consuming as, with some types of RCA connectors, the coaxial cable’s wires need to be soldered to the connector after stripping the cable with a stripping tool .
Are SO239 and PL259 the same?
So, I thought that our blog would be a good place to clear up any confusion once and for all! UHF-Male (or UHF Plug) is THE SAME as PL-259. UHF-Female (or UHF-Jack) is THE SAME as SO-239.
What’s the difference between PL-259 and RG-58?
While there are differences between different types and brands of PL-259 plugs, all will accept the 0.405 inch cable. The so-called thin cables are a bit more complex to categorize. Most of the common cables fall into one of two diameters – either 0.195 or 0.24 inches. RG-58, for example has a diameter of 0.195 inches.
How big is a coax plug for PL-259?
While there are many coax cables that are 1/2 inch in outside diameter, the true size of the cables that interface directly to PL-259 plugs is 0.405 inches. If you have a cable which is more than 0.405 inches in diameter, you can be pretty sure of a First, it is probably a good quality/low loss cable.
Can a soldering gun be used as a heat source?
Many people use soldering guns as a heat source. In order to have enough heat, the gun should have a high wattage rating, perhaps over 200 watts. Personally, I much prefer the butane torch. I find that the guns really don’t have enough heat, they take too long to heat up and too long to cool down, and, the cord always seems to get in the way.
What kind of solder is used for coax plugs?
The solder is the 60/40 type, with a rosin-core to provide flux(not acid-core). There are a few solder products on the market that advertise the ability to solder with less heatat lower temperatures. I have never used these products, but they look interesting.