How do you use the HM10 Bluetooth module?

How do you use the HM10 Bluetooth module?

BLE Scanner Android App

1. Once the installation is completed, open the App and enable Location and Bluetooth permission.
2. Scan for the bluetooth devices. The name of HM-10 BLE 4.0 is MLT-BT05. The default pairing code for MLT-BT05 is 123456789. So once connected, you are ready to go now.

How do I upgrade HM10?

Steps to Update Firmware in HM10 Bluetooth Module using Arduino Uno

1. Firstly, download and Upload the CCloader Sketch on Arduino Uno Using the Arduino IDE.
2. Now wire the HM-10/CC2541 Board to the Arduino according to below table after soldering the wires on HM-10 board:

Is HM10 a ble?

The HM10 is a serial BLE module (Bluetooth-Low-Energy) which is intended to use for the low power consumption applications and can last long even with a coin-sized battery. The HM10 is a Bluetooth 4.0 module based on the Texas Instruments CC2540 or CC2541 BLE System SoC (System on Chip).

What is difference between HC 05 and HM10?

Difference between HM10 and other Bluetooth Module The major difference HM10 possess is the Bluetooth Version. The HM10 is Bluetooth 4.0 module, so it comes with all Bluetooth Version 4.0 features such as speed, throughput and range. The HM10 offers a data rate of up to 24 Mbps with low-energy/low-power consumption.

How do you program HM-10?

Just connect as following:

1. Connect 3.3V of Arduino to the VCC of HM-10.
2. Connect GND of Arduino to the GND of HM-10.
3. Connect D8 of Arduino to RX of HM-10.
4. Connect D7 of Arduino to TX of HM-10.
5. Connect D2 of Arduino to the long leg of LED along with a 220 ohm resistor.
6. Connect the short leg of LED with the GND of Arduino.

What is HM-10 Bluetooth module?

HM-10 BLE Bluetooth 4.0 CC2541 Wireless Module is a BLE module for an embedded system to get BLE wireless communication with BLE capable devices (e.g. Android, iPhone, and iPad).

How do you program HM 10?

How do I change the baud rate of HM-10?

1. There are 2 versions of the HM-10; the HM-10C and the HM-10S.
2. Tapping one of the labels will read the characteristic value. For example, under Device Name, tapping the.
3. At the bottom of the serial monitor, set the baud rate to 9600 and using the above sketch means we can have line end characters selected:

What is HM module?

The HM-10 is a readily available Bluetooth 4.0 module. This module is used for establishing wireless data communication. The module is designed by using the Texas Instruments CC2540 or CC2541 Bluetooth low energy (BLE) System on Chip (SoC).