Contents
How does an automatic water pump turn on?
The pump will automatically turn on if the water level in the tank decrease (cross the green wire). And the Pump will stop when the water level touch the red wire. The circuit is very simple, You can easily make this project with some basic electronics components. You have to select the Relay as per the Pump voltage and current rating.
How does automatic water level control with an automatic pump control system work?
The project “automatic water level control with an automatic pump control system” is design to monitor the level of liquid in the tank. The system has an automatic pumping system attached to it so as to refill the tank once the liquid gets to the lower threshold, while offing the pump once the liquid gets to the higher threshold.
When does the submersible water level controller stop?
The pump will automatically turn on if the water level in the overhead tank decrease (below the green wire). And the Pump will stop when the water level in the overhead tank touches the red wire. Now, if the water level in the underground tank comes below UL1 level, the pump will automatically stop although the overhead tank water level is low.
Is there a rainbro oil free submersible pump?
. RainBro Oil Free Stainless Steel Submersible Utility Pump, Water Pump, 1/2 HP, 30ft. Power Cord, Model# SUP050 . . Only 8 left in stock – order soon.
How to build a pump controller and circuit?
We used the following items for this build: (If you use my links I receive a small commission. Thanks) 1 circuit board with 4 threaded standoffs and 8 screws Two 1/4″ bolts with nuts and washers 4 lengths of wire (16 gauge will work) The circuit board is the heart of this system.
What kind of power supply does a water pump controller use?
Built around only one NAND gate IC ( CD4011 ), the circuit is simple, compact and economical. It works off a 12V DC power supply and consumes very little power. The circuit can be divided into two parts: controller circuit and indicator circuit.
How are the wires connected to the pump?
Two 16 gauge wires around 1 foot in length are cut, stripped, and attached to the two cut white wires of the pump cord. These wires will run to the 120V side of the solid state relay. All of these connections can now be soldered with everything being taped up as nicely as possible.