Contents
How does Hal _ I2C _ master _ transmit work?
This function transmits a “master to slave” packet on SDA line. In the stm32f4xx_hal_i2c.c code after sending slave address there is a loop ( while (hi2c->XferSize > 0U)) that sends bytes which we want to be transmitted to slave. This loop works until all bytes are transmitted.
Which is HAL library does STM32F4 microcontroller use?
As controller I use a STM32F4 microcontroller, this controller use the HAL libraries from STM. I made a ‘library’ to control the LCD. But when I want to send data to the LCD, the I²C bus doesn’t work good. The first step is to send the address of the LCD. The address is: 01111110.
How does Hal treat a slave transmits on interrupt?
The way that HAL treats a slave transmits on interrupt is that it relies on an interrupt to be generated for each byte of the transfer instead of one interrupt for transferring all the bytes at once? Yes I think you understood that correctly. And if you think about it, that’s the whole point of interrupts.
Why do we need to shift address in I2C?
STM32 HAL_I2C_Master_Transmit – Why we need to shift address? after stumbling upon very strange thing I would like to find out if anyone could provide reasonable explanation. I have SHT31 humidity sensor running on I2C and after trying to run it on STM32F2 it didn’t work.
What is the sequential transmit function in Hal?
HAL_I2C_Master_Sequential_Transmit_IT(I2C_HandleTypeDef*hi2c, uint16_t DevAddress, uint8_t *pData, uint16_t Size, uint32_t XferOptions) Sequential transmit in master mode an amount of data in non-blocking mode with Interrupt. HAL_StatusTypeDef
What does stm32l4xx _ Hal _ i2c.c.definition?
Definition at line 2221 of file stm32l4xx_hal_i2c.c. Receives in master mode an amount of data in blocking mode. : Pointer to a I2C_HandleTypeDef structure that contains the configuration information for the specified I2C.
How to reset the busy flag after I2C initialization?
The SCL and SDA transition can be forced by software configuring the I2C I/Os in output mode. Then, once the analog filters are unlocked and output the SCL and SDA lines level, the BUSY flag can be reset with a software reset, and the I2C can enter master mode. Therefore, the following sequence must be applied: