Contents
How much fluid does a 4L60E filter change?
The fluid capacity of the 4L60e is 12 quarts of transmission fluid (dry). This amount is based on a stock, “shallow” transmission pan with a 12″ torque converter.
Why you should never change transmission fluid?
If you don’t change your transmission fluid frequently, the dirty fluid will not serve as an effective lubricant and it won’t disperse heat well. This will cause wear and tear on the clutches and other parts of your transmission.
Should I flush 4L60E?
You’ve just changed ALL of you trans fluid. This is not a back-flush and will not dislodge any particles in the tranny. It is completely safe and easy to do. It may sound difficult, but once you get the fitting made, you can do a complete flush in less than an hour for only the cost of the fluid.
Does Chevy recommend transmission flush?
When Should You Change the Transmission Fluid in Your Chevrolet? For a manual transmission, it’s generally recommended that you change the fluid every 30,000 to 60,000 miles. For an automatic it could be anywhere from 30,000 to 100,000 miles.
What type of fluid does a 4L60E take?
DEXRON III
Transmission Fluid
| Manufacturer | Transmission Type | Transmission Fluid |
|---|---|---|
| CHEVROLET | 4L60E | DEXRON III |
| ISUZU | 4L60E | DEXRON III |
| OLDSMOBILE | 4L60E | DEXRON III |
| PONTIAC | 4L60E | DEXRON III |
How do you drain the fluid on a 4L60E?
Removal Procedure
- Locate the upper transmission line on the passenger side and remove the line from your vehicle’s radiator.
- Once the line is removed, connect your brass trans cooler line fitting.
- Route the tubing to your catch pan or bucket.
- Now you will begin to flush the fluid.
How long does dexron last?
Typical fluid change intervals for automatic transmissions range from 40,000 to 60,000 miles depending on the severity of the usage. See your owner’s manual.
Is transmission flush good or bad?
A transmission flush is a perfectly safe service for your car, and is worth the extra money it costs. Transmission flushes have a bad rap however as some people expect a flush to fix major problems, such as slipping and stalling.
Can I use dexron VI instead of dexron II?
Valvoline DEXRON™-VI ATF can be used in new and old GM transmissions, is fully backward serviceable, and can be used wherever DEXRON™-II and/or DEXRON™-III are recommended.
What are some common problems with the 4L60E transmission?
Three of the most common problems found in a GM 4L60E transmission are: 3 – 4 Clutch Pack Failure Broken Drive Shell Worn TCC Regulator Valve
How many quarts of fluid to fill 4L60E at service?
The 4L60e’s fluid volume is 12 quarts (dry) of transmission fluid. This volume is based on a stock, with a 12 “torque converter,” shallow “transmission pan.” The ability of additional fluid will range from an extra quart or more with a deep pan.
Does the 4L60 have overdrive?
The 4L60 was manufactured by General Motor’s Corporation and was available from 1990 to 1992. The 4L60 was the first automatic overdrive transmission specifically designed for rear-wheel high performance applications.
How many solenoids are on the 4L60E transmission?
The 4L60E family of transmissions use 2 shift solenoids, initially called Shift Solenoid A & Shift Solenoid B, later changed to comply with OBD II (On Board Diagnostics revision 2) regulations to 1-2 Shift Solenoid & 2-3 Shift solenoid.