Contents
How routers communicate with each other?
This communication allows each router to tell one another where different networks are located. Routers tell surrounding routers about the network directly attached to their interfaces, as well a non-directly-attached network which it has learned from other routers. This is done through a routing protocol.
How do I communicate with two IP addresses?
Open Network (and Dial-up) Connections. Click Properties. Click Internet Protocol (TCP/IP) then click Properties. Click Advanced. Type in the new IP address then click Add.
Is having 2 routers bad?
Its okay to have multiple routers on the network, as long as they are configured correctly. You want to have a router, not a switch, acting as your gateway connected to your cable modem. This router should have Wi-Fi disabled and it should be running a DHCP server to assign out IP addresses.
Can I use 2 modems on the same line?
If you don’t have a direct DSL line built into your wall (as is usually the case with older homes) you need to connect your DSL modem to a phone line. However, if you are using two different DSL modems in the same room you need to plug the two different DSL modems into the same phone line.
What is the main function of a dynamic routing protocol?
Dynamic Routing Protocol Operation A primary benefit of dynamic routing protocols is that routers exchange routing information when there is a topology change. This exchange allows routers to automatically learn about new networks and also to find alternate paths when there is a link failure to a current network.
How can hosts on two different VLANs communicate?
Two separate VLANs must communicate through a layer-3 device, like a router. Devices on a VLAN communicate with each other using layer-2. Layer-3 must be used to communicate between separate layer-2 domains.
Can a subnet communicate with another subnet in a VNET?
Unlike On-Premises, communications are allowed between subnets in a VNET by default. If you have 20 subnets withing a VNET, then all 20 subnets can communicate with each other by default. You don’t need to add any NSG or Route table to achieve this.
Can a NSG subnet communicate with another subnet?
There are default rules in NSG which cannot be deleted. So those rules are applied when you don’t have any manual rules applied. Unlike On-Premises, communications are allowed between subnets in a VNET by default. If you have 20 subnets withing a VNET, then all 20 subnets can communicate with each other by default.