How to align vertices in a straight line in Autodesk?

How to align vertices in a straight line in Autodesk?

In EditPoly there is another option, Make Planar, it has three axis buttons you can click. 07-30-2009 07:50 AM 07-30-2009 07:50 AM Thanks, that’s what I was looking for – especially the Make Planar. 07-30-2009 07:51 AM 07-30-2009 07:51 AM Snap to Vertex, Snaps Use Axis Constraints, set the appropriate Axis Constraint.

How to align vertices into a straight line in Blender?

With all 3 vertices selected, and one of the ends selected last, so active, and the new transform orientation active, hit S Shift Y 0, scaling to 0 in all dimensions, except ‘Y’, the one along the line between the end vertices. Thanks for contributing an answer to Blender Stack Exchange!

How to line up vertices along a line?

On a line, I need to line up the bottom vertex points in relation to a top reference vertex point. How could I reset the X Y and Z coordinates of these vertex points to essentially line them up all through use of the vector of the reference point vertex. I do not have access to Mesh -> Transform -> Scale on Axis for aligning vertices along a line.

How to align an edge to a transform?

Align to a custom Transform Orientation. 1 1. In Vertex Select Mode, draw an edge. You can use Ctrl +LeftClick to create and then extrude vertices. Then with the entire edge selected, snap the 2 2. Create a custom Transform Orientation from the edge. 3 3. Select it for use. 4 4. Scale along it.

How to line up vertices in a blender Stack Exchange?

There are several ways to go about aligning vertices, best would be a combination of these for either organic or hard surface modeling. For your use case, the first should suffice. Select the relevant vertices and scale while constraining to an axis, change the Transform Orientation so it aligns as you want it.

How to snap to vertex in a straight line?

Snap to Vertex, Snaps Use Axis Constraints, set the appropriate Axis Constraint. Disadvantage: only works on 1 vertex at a time (any others will move relative to the one “grabbed”). Advantage: works on Editable Splines, Polys, Meshes, NURBS CV points… Win7Pro x64 (SP1). i5-3570K @ 4.4GHz, 8Gb Ram, DX11.

How does snap to vertex work in Autodesk?

07-30-2009 07:51 AM 07-30-2009 07:51 AM Snap to Vertex, Snaps Use Axis Constraints, set the appropriate Axis Constraint. Disadvantage: only works on 1 vertex at a time (any others will move relative to the one “grabbed”).