How to calculate the current of a MOSFET gate?

How to calculate the current of a MOSFET gate?

I have calculated the gate current as Igs = Qg/t. For example, I want to drive IRF540n with PWM at 100 kHz. It has Qg = 94 nC and 100 kHz = 10000 ns. If I use Igs = Qg/t then Igs = 94/10000 = 0.0094 A.

How to calculate maximum PWM frequency for MOSFET-circuit?

There are a lot of delay times given but even if I take the highest number (200ns) for ‘turn-off time’ this would result in 5 MHz. But this would mean that even on a 95% duty cycle the MOSFET would still need it’s 200ns to go off… So the Hz number has to be much lower.

How much current does a Vgate need to charge?

Vgate = 12V from my circuit. This is obviously wrong because it definitely needs more than 1.15 mA to charge the the gates. Now this seems more realistic, maybe a little high, but is completely contradictory to the first method / formula of calculating gate current.

How to calculate the charge time of a gate?

The section headed “Gate Charge” is a good read for this problem. It can be simplified down to the standard RC formulae for calculating charge time of a capacitor τ = R × C – the capacitance of the gate, multiplied by the resistance of the circuit portion charging or discharging the gate.

What should Fos be for MOSFET gate driver?

RG2 will limit the power delivered by the MOSFET driver which can be tuned to limit tON. MOSFETs need to be matched to the power requirements with a factor of safety (FoS) of at least 1.2 for both currents and voltages.

What is the dynamic characteristic of a MOSFET?

A dynamic characteristic which is the total charge of the MOSFET’s gate [nC]. It can be employed to estimate the instantaneous current needed to turn on a MOSFET in a specifed time. This is a design parameter to maximize or minimize the worst case input gate current [ns].

Can a gate driver chip sink more current than the source?

Usually a gate driver chip will sink more current than it will source. Like almost everything electrical a mosfet gate will only draw the amount of current it needs. More current available will help turn the mosfet on, and not hurt the gate. It’s voltage that gets applied to the gate that will harm it not the current.