How to create a VPN tunnel between two Asas?
This document describes how to configure a site-to-site Internet Key Exchange Version 2 (IKEv2) VPN tunnel between two Adaptive Security Appliances (ASAs) where one ASA has a dynamic IP address and the other has a static IP address. There are no specific requirements for this document.
Can a Cisco ASA be used as a VPN?
The Cisco ASA is often used as VPN terminator, supporting a variety of VPN types and protocols. In this tutorial, we are going to configure a site-to-site VPN using IKEv2. IKEv2 is the new standard for configuring IPSEC VPNs.
Is there a tunnel between 2 Asa 5506-x?
Hi, been battling today to bring up a tunnel between 2 ASA 5506-X using IKEv2 with the same pre-shared key. Short summary, followed by “show run” from both. – GE1/2 10.2.2.1/24 – connected to ASA2 GE1/2 as well as a desktop computer. This is the local network. – GE1/2 10.2.2.2/24 – connected to ASA1 GE1/2 as well as a desktop computer.
How to setup a site to site IPSec VPN on ASA?
ASA2 (config)# access-list ACL2 extended permit ip 192.168.2.0 255.255.255.0 192.168.1.0 255.255.255.0 The next step is to define a tunnel group. There are two default tunnel groups in the ASA: DefaultRAGroup is the default IPsec remote-access tunnel group and DefaultL2Lgroup is the default IPsec LAN-to-LAN tunnel group.
Can a dynamic Asa allow a defaultl2l tunnel?
The DefaultL2L Group is a preconfigured tunnel group on the ASA and all connections that do not explicitly match any particular tunnel group fall on this connection. Since the Dynamic ASA does not have a constant predetermined IP address, it means the admin cannot configure the Statis ASA in order to allow the connection on a specific tunnel group.
How to start an IPSEC tunnel with Asa?
Note : On the ASA, the packet-tracer tool that matches the traffic of interest can be used in order to initiate the IPSec tunnel (such as packet-tracer input inside tcp 192.168.1.100 12345 192.168.2
Can you use named Tunnel groups on static Asas?
The advantage of using named tunnel groups on the static ASA is that when the DefaultL2LGroup is used, the configuration on the remote dynamic ASAs, which includes the pre-shared keys, has to be identical and it does not allow for much granularity with the setup of policies.