How to create smooth contour polygons in QGIS?

How to create smooth contour polygons in QGIS?

Run a majority filter to ‘clean up’. (Processing Toolbox>SAGA>Raster Filter>Majority Filter) Created contours from the filtered grid at intervals of 1, and stored them in an attribute ‘class’ (because my classes were 1,2,3,4,etc).

How to convert raster to polygons in QGIS?

Then I use QGIS Polygonize. Then use zonal statistics to the original raster to get the value on the polygons. The 2nd method I tried was to convert raster to polygon. Then create a new attribute column rounded to the contour I desire.

Where are the points in a contour polygon?

Each contour (see the exceptions above) will have an upper and lower polygon, so if we create two points per contour polyline – one on the left side and one on the right side very close to the original polyline, one of the points will be in the lower polygon and the other point in the upper polygon.

What do you mean by contour in GIS?

A contour is a polyline points of equal height. By their nature the contours are polyline features, but many GIS users want to represent the area closed between two adjacent contours with a polygon.

Is there a way to clean up contours?

If you want you can also use Smooth tool on your contour layer. It smooths all the features in your layer. I’ve never had much luck cleaning up contours as linework.

What’s the best way to smooth out a raster?

Instead smooth your raster to take the lumps and bumps out – easier maths and no topology to worry about. I find resample slightly up (cellsize x 1.5) and then back down to the original (or better) cell size works wonders in cleaning up the raster, which will in turn produce smoother and more pleasing contours.

How is the grass tool used in QGIS?

This is the module on which the QGIS Generalizer Plugin in Bryan’s answer is built. The GRASS tool allows you to use polygons so you can avoid the steps of converting to lines and back again.