Contents
How to enable the wireless network adapter on CentOS 7?
The CentOS 7 image was of minimal install as I had only 4 GB of pendrive available. The wifi driver named wlp18s0b1 shows in the list if I do ip link but it’s configuration file is not there in the /etc/sysconfig/network-scritps/ so I can’t enable this interface using ifup. ifup wlp18s0b1 says the following.
How to install GNOME 3 on RHEL / CentOS 7?
To install GUI (Gnome 3) on RHEL/CentOS 7 minimal installation server, run the following yum command. On CentOS 7 [ root@tecmint ~]# yum –disablerepo=* –enablerepo=centos7 groupinstall “GNOME Desktop” On RHEL 7
Do you need a GUI in CentOS 7?
As a Linux administrator for more than 6 yrs, I spend most of my time working on terminals, but there are some situations where I need a GUI instead of terminal. By default, RHEL/CentOS 7 server installed as minimal without any Graphical Desktop support. So, to install GUI on the top of minimal installation, we have two options:
How to configure Red Hat Linux to use GDM?
To configure Red Hat Linux to use gdm and automatically start the GNOME desktop environment, follow the steps below. Edit the /etc/sysconfig/desktop file to define GNOME as the X desktop environment that loads on connection. Open the /etc/sysconfig/desktop file. Locate the DESKTOP= entry.
How to connect wireless network adapter to VMware Workstation?
While pressing Ctrl key, select both your wireless and recently created local loop network. right click on it and create the bridge. Now in virtual network editor in vmware, select the network with type “Bridged” and change Bridged to option to the recently created bridge. You will then have access to network via wifi card.
Do you need hardware to use WiFi in CentOS?
Yes you need the hardware to be active (it may already be, can you see a wireless interface?). Drivers are just kernel modules in Linux. Or make sure that NetworkManager-wifi is installed and use the GUI. CentOS 6 died in November 2020 – migrate to a new version! CentOS 5 is dead, do not use it.
How to boot from USB in VMware Player?
If you are not using Workstation Player then probably you want to know how to Boot VM from USB in VirtualBox. 1. Create a new virtual machine 2. Specify the Disk Storage capacity 3. Edit Virtual Machine Setting 4. Add bootable USB to Vmware Virtual Machine 1. Select Hard Disk 2. Hard Disk Type 3. Use a Physical Disk (for Advanced Users) 4.