How to interface GSM and GPS module with Arduino?
About this project
- Step 1: Connect the TX and RX Pin of the GPS to D3 and D4.
- Step 2: Connect the LCD to the D8 to D13 of the Arduino Board.
- Step 3: Add Tiny GPS Library.
- Step 4: Download the Arduino Code From the Attachment.
- Step 5: Type “TRACK VEHICLE” to the Sim on the Sim Module.
How to send GPS location via SMS using GSM and Arduino?
The GPS receiver obtains the data as a whole NMEA format text. Only the latitude and longitude coordinates are taken from it; using the Arduino TinyGPS library. Then the GSM module sends SMS to the number specified in the code….GSM module Connection with Arduino.
| Arduino Pin | GSM Module Pin |
|---|---|
| GND | GND |
How to GET location using GSM?
The way the network location feature works is that the GSM device gets the location of the network tower it is connected to. The server in the network towers is programmed to a hard coded location coordinate values which can be retrieved by the GSM module through a GPRS connection.
How to interface a GSM module to Arduino?
Now let’s see how to connect a gsm module to Arduino! There are two ways of connecting GSM module to arduino. In any case, the communication between Arduino and GSM module is serial. So we are supposed to use serial pins of Arduino (Rx and Tx).
Which is the best GSM modem for Arduino?
The most popular modem under use is SIM 900 gsm modem from manufacturer SIMCom. They also manufacture GSM Modems in bands 850, 300 and other frequency bands. 3. Check for TTL Output Pins in the module – You can feed the data from gsm module directly to Arduino only if the module is enabled with TTL output pins.
How to send and receive SMS with Arduino?
1) Send SMS using Arduino and GSM Module – to a specified mobile number inside the program 2) Receive SMS using Arduino and GSM Module – to the SIM card loaded in the GSM Module. so that’s the program/code to make arduino send sms and receive sms using gsm module! Let’s get to explanation of program!
How to use Arduino as an alternative to GPS?
Go to www.arduino.cc/en/Main/Software and download the Arduino software compatible to your OS. Install the IDE software as instructed. Run the Arduino IDE and clear the text editor and copy the following code in the text editor. Choose the board in tools and boards, select your Arduino Board.