How to pair HM 10?

How to pair HM 10?

BLE Scanner Android App

1. Once the installation is completed, open the App and enable Location and Bluetooth permission.
2. Scan for the bluetooth devices. The name of HM-10 BLE 4.0 is MLT-BT05. The default pairing code for MLT-BT05 is 123456789. So once connected, you are ready to go now.

How do I reset hm10?

Factory Reset a HM-10

1. AT+RENEW Restores factory defaults.
2. AT+RESET Reboot HM-10.
3. AT Wait for OK.
4. AT+MARJ0x1234 Set iBeacon Major number to 0x1234 (hexadecimal)
5. AT+MINO0xFA01 Set iBeacon Minor number to 0xFA01 (hexadecimal)
6. AT+ADVI5 Set advertising interval to 5 (546.25 milliseconds)

How do I use an Arduino command?

The following AT commands should be written in the Arduino’s serial monitor (in order) to program the ESP8266:

1. “AT” This will check if the module is connected properly and its functioning, the module will reply with an acknowledgment.
2. “AT+RST” This will reset the wifi module.

What is the characteristic value of the HM10?

The HM10 after sending the AT+START, does advertise packets, and can detect the service and characteristic, But the characteristic value is the default 0x00, How can I change that? Have checked the data sheet multiple times but can not find an AT command that is capable of doing the same.

What kind of emulation device is the HM10?

The HM10 is a serial-port emulation device – whatever serial data you send to the HM10 module (aside from the AT commands) is made available on it’s BLE characteristic. Unfortunately the data sheet doesn’t document the service and characteristics, but this code suggests that the serial RX/TX characteristic is 0000ffe1-0000-1000-8000-00805f9b34fb

Are there any programmable pins on the HM-10?

HM-10 Programmable Pins. The HM-10 has 10 pins that can be user controlled, a couple are input only, the others can be input or output. Unfortunately, the pins we can control are not available on the breakout board so we need to attach a connection directly to the actual HM-10 (the small daughter board).

Is the HM-10 a Bluetooth 4.0 module?

The module. The HM-10 is a readily available Bluetooth 4.0 module based on the Texas Instruments CC2540 or CC2541 Bluetooth low energy (BLE) System on Chip (SoC). The module design and firmware originated from the Jinan Huamao Technology Company (JNHuaMao), but is sold by various suppliers. For the class, we got the HM-10 shipped on…