Contents
How to properly use external memory flash with MCU?
So I plan to use parallel flash memory with a dsPIC33 MCU (I’ll use the DSP capabilities to compute data that will be store in the flash memory). My data will be 16 bits word but the sdPIC only ave an 8bits parallel memory bus)
How much external memory does a PIC24F / 24h / dspic33f have?
The PIC24F/24H/dsPIC33F architecture supports up to 64 Kbytes of internal data memory. If internal memory is insufficient, the external memory can be used. But, this external memory cannot be directly accessed by the CPU of the controller.
Are there any code examples for the dsPIC33?
Code examples: we will look at some simple code that you can implement to perform some basic functions. Caution: All recommendations and code examples have been tested with the dsPIC33EP128GP502. If you are implementing a different device, please check its datasheet and product information as there might be some minor differences.
What kind of power supply does a dspic33e have?
These connections are basically connecting your power supply to the different Vdd (logic/digital supply) and AVdd (analogue supply) pins as well as the GND of the power source. Your power source could be 5V or 3.3V depending on your choice of MCU, normally for dsPIC33E’s 3.3V is the norm.
Why do microcontrollers have so little RAM?
To enable very low power sleep, SRAM is used due to its ability to maintain its contents with extremely low power consumption. Battery backed SRAM can hold its state for years off of a single 3V button battery.
Which is low power MCU is really the lowest power?
The STM8L 101 series of 8-bit low power MCUs from STMicroelectronics is another low power MCU. It consumes 350nA in its lowest power mode but this includes the on-chip regulator that is standard on the family. As usual, there are several modes to choose from: wait, active-halt and halt.
Why is NodeMCU running on a low power battery?
The two immediate suspects are the power regulator, and the UART, as discussed in the forum here. The first step is to target the power regulator. The AMS1117 LDO draws a quiescent current of “typically” 5mA. To prevent this, it may be sufficient to lift just pin 1. However, I chose to remove the whole chip to free up space for later.