Contents
How to run DHCP command in U-Boot?
At the U-Boot prompt, run the dhcp command to invoke DHCP client to obtain an IP address and boot the board: U-Boot>dhcp BOOTP broadcast 1 DHCP client bound to address 172.17.11.49 TFTP from server 172.17.0.1; our IP address is 172.17.11.49 Filename ‘psl/m2s/networking.uImage’.
Which is the first step in configuring a DHCP client?
The first step for configuring a DHCP client is to make sure the kernel recognizes the network interface card. Most cards are recognized during the installation process and the system is configured to use the correct kernel module for the card.
Which is UDP port does DHCP client use?
The traditional approach to traffic classification on IP networks associates an application with a TCP or UDP port number. For example, HTTP uses port 80 and FTP uses port 21. But this approach fails with peer-to-peer traffic because as much as 60% of peer-to-peer traffic appears on random port numbers.
How to create a DHCP address pool on a router?
Creates a DHCP address pool on the router and enters DHCP pool configuration mode. The name argument can be a string or an integer. Defines subnet number (IP) address for the DHCP address pool, optionally including the mask. Imports DHCP option parameters into the DHCP portion of the router database.
How does U-boot search for a command?
As you enter the first letters of a command, U-Boot searches its list of built-in commands until it finds a match. For example, if you enter save or sav or even sa, U-Boot executes the saveenv command.
How can I Stop U-boot from autobooting?
To stop the automatic booting (autoboot) of the pre-installed kernel, send a character to the serial port by pressing a key from the serial console connected to the target. If U-Boot is stopped, it displays a command line console (also called monitor).
What does U-Boot do when you interrupt the boot sequence?
Once the execution is handed over to U-Boot, it offers you a few seconds to interrupt the boot sequence, as shown in Listing 2. If you choose not to interrupt, U-Boot executes an environment variable called bootcmd. bootcmd holds the search sequence for a file called uImage.