How to sand sharp corners?
Cut or fashion a 1/4-by-3/4-by-3-inch piece of wood into a long, sharp wedge. Fold the sandpaper over the sharp end and use it to sand inside tight corners. The wedge works similar to a surgical tool, allowing you to sand in short, focused strokes with some power behind them.
How do you clean furniture after sanding?
The most effective way to clean wood after sanding is to brush all the dust off the wooden surface using a painters dust brush and then wipe the surface with a lint-free rag and mineral spirits. The mineral spirits will clean any grime or grease off of your surface making it ready for painting or staining.
Can I sand furniture by hand?
Always sand with the grain of the wood, making long, light, even strokes with a padded sanding block. Sanding, more than any other part of refinishing, is a process that can’t be rushed. It must be done by hand; power tools can damage the wood.
What is the fastest way to sand a table?
Begin sanding the entire wood surface with coarse-grit sandpaper (80 grit), then progress to medium-grit sandpaper (150 grit), and then to a fine-grit sandpaper (220 grit) before you stain. When sanding, sand the entire table with each grit before moving on to the next grit.
How do you get into corners when sanding?
Tip 5: Stick Sandpaper to a Putty Knife to Reach into Tight Corners. It’s difficult to sand “with the grain” into tight corners without scratching the adjacent wood. Here’s a tip that works great for those hard-to-reach areas. Wrap an adhesive-backed sanding discover the edge of a flexible putty knife.
What kind of grit should I use to scuff wood?
If you are scuffing bare wood, or another surface, in preparation for priming, painting, and/or staining, you will need something between P120 and P150. If you are scuffing between coats of paint or sealer, choose something between P180 and P220. If you are sanding between coats of varnish and need a high-gloss finish, look for a P320 grit.
What kind of sand do you use to scuff paint?
If you are scuffing between coats of paint or sealer, choose something between P180 and P220. If you are sanding between coats of varnish and need a high-gloss finish, look for a P320 grit. For high-gloss varnish, polyurethane, and lacquer finishes, wet sand with P600 or P800. 3
What kind of Sander do you use to rub out wood?
A hard felt block is typically used for rubbing out finishes. However, its size and relatively soft composition afford great control as a backer for light-pressure sanding. Sanding between coats of finish is necessary to knock down dust nibs and level any drips or other imperfections.
What kind of Sander do you use to sand corners?
For sanding corners, the suggested power tool is the detail sander with a triangular sanding pad. You’ll find a lot of similarities between an orbital sander and a detail sander. But this one does a better job in every way as sanding tight corners is no big deal. sanding tight wood corners with Detail Sander=>