Contents
How to select All tracks on a KiCad board?
When I do the track selection in KiCAD and click Select -> Connected Tracks it also selects tracks connected through vias on the back of the board. I only want to select tracks on the current layer.
What’s the minimum thickness for a KiCad circuit?
In your board, there might be different current levels. If your Layer 1 thickness is one ounce copper and if you want a track to carry one-amp current, then your track width should be minimum 40 mils. But there are also milliamp currents flowing through your circuit so you won’t use 40-mil widths for all the nets.
How to set up design rules in KiCad?
Now, your PCB design rules in KiCad are set. You can see them at the top of the screen. The unit is mils. If you want to shift to mms, click the mm button on the left hand side. If you want to route tracks, click this button on the right-hand side.
How can I edit the text on my KiCad board?
You can now go to Text & Graphics. This is where you can edit the text that will appear on your board. Choose the height, width, line thickness, etc. Let’s discuss net classes. It is important to go over these design rules in KiCad. You can see over here, there are different nets. And you can see there is a default class available.
Can you change the trace layer in KiCad?
If you re-draw a trace somewhere else, KiCad automatically deletes the connection that you replaced, so there’s no need to first delete it. As far as I know, the only way to change a trace’s layer is to re-draw it.
What’s the difference between copper and component in KiCad?
The copper layer is traditionally the “bottom,” whereas the component layer is the “top,” or the side with the components. Pressing the “v” key switches between these two layers. So if you start out on the wrong layer, press Esc, and then “v” and start again. “v” also creates a via if you’re in the middle of drawing a traces.
How to make power and ground traces in KiCad?
It’s a good idea to make power and ground traces as think as possible. To change an existing track’s width, first change the overall program’s track width using the dialog as before or the pull-down menu, and then right click on the trace. Via sizes are changed the same way.
What’s the key to drawing traces in KiCad?
Pressing the “v” key switches between these two layers. So if you start out on the wrong layer, press Esc, and then “v” and start again. “v” also creates a via if you’re in the middle of drawing a traces.
How is adhesive paste used to make KiCad?
Most common technique is adding adhesive paste to the components soldered in first place so they cannot fall down when the card is flipped and heated in the oven the second time. This is the purpose of the F.Adhes and B.Adhes layers in Kicad.