How to use Exec to redirect stdout to the terminal?
We then use exec to redirect STDOUT to the /dev/tty to restore standard output to the terminal. This effectively stops the redirection. Using the cat command we can see that the file contains all the redirected output. In this article we covered the basics of the exec command.
What happens when you run exec after a command?
If you run exec followed by a command, that command will REPLACE the original process, it will NOT create a sub-shell. An additional feature of the exec command, is redirection and manipulation of file descriptors. Explaining redirection and file descriptors is outside the scope of this tutorial.
How to use Exec to redirect output in Bash?
In the example animation below, we use exec to redirect all standard output to a file. We then enter some commands that should generate some output. We then use exec to redirect STDOUT to the /dev/tty to restore standard output to the terminal. This effectively stops the redirection.
When to use Exec to redirect a file descriptor?
When a file descriptor is redirected with exec it affects the current shell. It will exist for the life of the shell or until it is explicitly stopped. If no command is specified, redirections may be used to affect the current shell environment. Here are some examples of how to use exec for redirection and manipulating file descriptors.
How to redirect exec output to a buffer?
When it gets EOF on the pipe, it knows the child has finished and closed the pipe; it can close its end of the pipe too. Since you look like you’re going to be using this in a linux/cygwin environment, you want to use popen. It’s like opening a file, only you’ll get the executing programs stdout, so you can use your normal fscanf, fread etc.
How to redirect standard output to a file?
Child reorganizes things so that file descriptor 1 (standard output) goes to the file. Usually, you can leave standard error alone; you might redirect standard input from /dev/null. Child then execs relevant command; said command runs and any standard output goes to the file (this is the basic shell I/O redirection).
How to recover standard output after exec 1?
You have to prepare for the recovery before you do the initial exec: To recover the original standard output later: The first exec copies the original file descriptor 1 (standard output) to file descriptor 3, then redirects standard output to the named file.
How to stop exec 1 > file in Linux?
The first exec copies the original file descriptor 1 (standard output) to file descriptor 3, then redirects standard output to the named file. The second exec copies file descriptor 3 to standard output again, and then closes file descriptor 3.
When does exec replace the shell process in Bash?
Since the tail command replaced the bash shell process, the shell will close when the tail command terminates. If the -l option is supplied, exec adds a dash at the beginning of the first (zeroth) argument given. So if we ran the following command: