Contents
Is clickable in Selenium Java?
WebDriverWait inconjunction with ExpectedConditions as elementToBeClickable() returns the WebElement once it is located and clickable i.e. visible and enabled.
How do I know if a Webelement is clickable?
We can check if the element is clickable or not in Selenium webdriver using synchronization. In synchronization, there is an explicit wait where the driver waits till an expected condition for an element is met. To verify, if the element can be clicked, we shall use the elementToBeClickable condition.
How do you handle non clickable exceptions?
The solution is to make sure that the overlapping element is closed before you try to click on another element. Another solution is to switch to the layer that contains the element you want to click.
Why is click ( ) not working in selenium?
Looking at your xpath you have not identified the button, instead you are pointing to the span tag inside which button is present. Selenium clicks on span instead of the button. That is why click () is not working.
Why does Java click ( ) not always work?
Make a break point before finding the element and look if your code runs fine. If there is a timing issue, use a an explicit Wait before clicking your button. Note also, that the button should be clickable (element must be visible AND enabled) before actually clicking it.
Can you click if an element is not present?
If you know for sure that the element is present, you could try this to simulate the click – if .Click () isn’t working A major thing to watch out for is whether a button is Enabled or not. You can still click them and nothing will fall over and the element is there but it is not ready to be clicked on so just doesnt do anything.
Why does Selenium WebDriver not work in IDE?
I have found that a lot of the commands that worked in IDE either fail to work or selenium web driver claims to not support at all. So far I’ve been tackling these issues one at a time which is less than ideal…